On the role of top dead center conditions in the combustion phasing of homogeneous charge compression ignition engines

Combustion Science and Technology

Volumn 179, Issue 9, 2007, Pages 2039-2063

  Babajimopoulos, Aristotelis ^a   Lavoie, George A ^a   Assanis, Dennis N ^a  

^a UNIVERSITY OF MICHIGAN   (United States)

Author keywords

Auto ignition; Chemical kinetics; HCCI combustion; Ignition delay; Ignition timing

Indexed keywords

COMBUSTION; PARAMETER ESTIMATION; REACTION KINETICS; THERMODYNAMIC PROPERTIES;

AUTO-IGNITION; HOMOGENEOUS CHARGE COMPRESSION IGNITION (HCCI) ENGINE; IGNITION DELAY; IGNITION TIMING;

IGNITION SYSTEMS;

EID: 34547572991     PISSN: 00102202     EISSN: 1563521X     Source Type: Journal    
DOI: 10.1080/00102200701386107     Document Type: Article

References (34)

1. Aceves, S.M., Flowers, D.L., Westbrook, C.K., Smith, J.R., Pitz, W., Dibble, R., Christensen, M., and Johansson, B. (2000) A Multi-Zone Model for Prediction of HCCI Combustion and Emissions. SAE Paper 2000-01-0327.
2. Agrell, F., Ångström, H.-E., Eriksson, B., Wikander, J., and Linderyd, J. (2005) Control of HCCI During Engine Transients by Aid of Variable Valve Timings Through the Use of Model Based non-linear compensation. SAE Paper 2005-01-0131.
3. Babajimopoulos, A., Lavoie, G.A., and Assanis, D.N. (2003) Modeling HCCI Combustion with High Levels of Residual Gas Fraction - A Comparison of Two VVA strategies. SAE Paper 2003-01-3220.
4. Babajimopoulos, A., Assanis, D.N., Flowers, D.L., Aceves, S.M., and Hessel, R.P. (2005) A fully coupled computational fluid dynamics and multi-zone model with detailed chemical kinetics for the simulation of premixed charge compression ignition engines. Int. J. Eng. Res., 6, 497-512.
5. Chang, J., Güralp, O., Filipi, Z., Assanis, D., Kuo, T.-W., Najt, P., and Rask, R. (2004) New Heat Transfer Correlation for an HCCI Engine Derived from Measurements of Instantaneous Surface Heat Flux. SAE Paper 2004-01-2996.
6. Choi, Y. and Chen, J.-Y. (2004) Fast prediction of start-of-combustion in HCCI with combined artificial neural networks and ignition delay model. Proc. Combust. Inst., 30, 2711-2718.
7. Curran, H.J., Gaffuri, P., Pitz, W.J., and Westbrook, C.K. (2002) A comprehensive modeling study of iso-octane oxidation. Combust. Flame, 129, 253-280.
8. Davidson, D.F., Gauthier, B.M., and Hanson, R.K. (2005) Shock tube ignition measurements of iso-octane/air and toluene/ar at high pressures. Proc. Combust. Inst., 30, 1175-1182.
9. Dec, J.E. and Sjöberg, M. (2003) A Parametric Study of HCCI Combustion - The Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection. SAE Paper 2003-01-0752.
10. Dec, J.E. and Sjöberg, M. (2004) Isolating the Effects of Fuel Chemistry on Combustion Phasing in an HCCI Engine and the Potential of Fuel Stratification for Iignition Control. SAE Paper 2004-01-0557.
11. Eng, J.A. (2004) The Effect of Fuel Composition on HCCI Combustion. Presented at the SAE Symposium on HCCI, August 10-11, 2004, Berkeley, CA.
12. Epping, K., Aceves, S., Bechtold, R., and Dec, J. (2002) The Potential of HCCI Combustion for High Efficiency and Low Emissions. SAE Paper 2002-01-1923.
13. Fiveland, S.B. and Assanis, D.N. (2000) A Four Stroke Homogeneous Charge Compression Ignition Engine Simulation for Combustion and Performance Studies. SAE Paper 2000-01-0332.
14. Gauthier, B.M., Davidson, D.F., and Hanson, R.K. (2004) Shock tube determination of ignition delay times in full-blend and surrogate fuel mixtures. Combust. Flame, 139, 300-311.
15. Halsted, M.P., Kirsch, L.J., and Quinn, C.P. (1977) The autoignition of hydrocarbon fuels at high temperatures and pressures-fitting of a mathematical model. Combust. Flame, 30, 45-60.
16. Haraldsson, G., Tunestal, P., Johansson, B., and Hyvonen, J. (2004) HCCI Closed-Loop Combustion Control Using Fast Thermal Management. SAE Paper 2004-01-0943.
17. He, X., Donovan, M.T., Zigler, B.T., Palmer, T.R., Walton, S.M., Wooldridge, M.S., and Atreya, A. (2005) An experimental and modeling study of isooctane ignition delay times under homogeneous charge compression ignition conditions. Combust. Flame, 142, 266-275.
18. Hiraya, K., Hasegawa, K., Urushihara, T., Nissan, A.I., and Nissan, T.I. (2002) A study on Gasoline-Fueled Compression Ignition Engine - A Trial of Operation Region Expansion. SAE Paper 2002-01-0416.
19. Kalghatgi, G. (2005) Auto-Ignition Quality of Practical Fuels and Implications for Fuel Requirements of Future SI and HCCI Engines. SAE Paper 2005-01-0239.
20. Kee, R.J., Rupley, F.M., and Miller, J.A. (1989) CHEMKIN-II: A Fortran Chemical Kinetics Package for the Analysis of Gas-Phase Chemical Kinetics, Report SAND89-8009, Sandia National Laboratories.
21. Livengood, J.C. and Wu, P.C. (1955) Correlation of autoignition phenomena in internal combustion engines and rapid compression machines. Proc. Combust. Instit., 5, 347-356.
22. Martinez-Frias, J., Aceves, S.M., Flowers, D.L., Smith, J.R., and Dibble, R. (2000) HCCI Engine Control by Thermal Management. SAE Paper 2000-01-2869.
23. Najt, P.M. and Foster, D.E. (1983) Compression ignited homogeneous charge combustion. SAE Paper 830264.
24. Olsson, J.-O., Tunestål, P., Ulfvik, J., and Johansson, B. (2003) The Effect of Cooled EGR on Emissions and Performance of a Turbocharged HCCI Engine. SAE Paper 2003-01-0743.
25. Onishi, S., Jo, S.H., Shoda, K., Jo, P.D., and Kato, S. (1979) Active Thermo-Atmosphere Combustion (ATAC) - A New Combustion process for Internal Combustion Engines. SAE Paper 790501.
26. Persson, H., Agrell, M., Olsson, J.-O., Johansson, B., and Strom, H. (2004) The Effect of Intake Temperature on HCCI Operation using Negative Valve Overlap. SAE Paper 2004-01-0944.
27. Rausen, D.J., Stefanopoulou, A.G., Kang, J.-M., Eng, J.A., and Kuo, T.-W. (2004) A mean-value model for control of homogeneous charge compression ignition (HCCI) engines. J. Dyn. Syst., ASME Trans., 127, 355-362.
28. Sankaran, R. and Im, H.G. (2004) Effects of mixture inhomogeneity on the autoignition of reactants under HCCI environment. Proceedings of the 42nd AIAA Aerospace Sciences Meeting and Exhibit, Jan 5-8, 2004, Reno, NV, pp. 10701-10708.
29. Shaver, G.M., Gerdes, J.C, Jain, P., Caton, P.A., and Edwards, CF. (2003) Modeling for control of HCCI engines. Proceedings of the American Control Conference, June 4-6, 2003, Denver, CO, pp. 749-754.
30. Sjöberg, M. and Dec, J.E. (2004) An Investigation of the Relationship between Measured Intake Temperature, BDC Temperature, and Combustion Phasing for Premixed and DIHCCI Engines. SAE Paper 2004-01-1900.
31. Thring, R.H. (1989) Homogeneous Charge Compression Ignition (HCCI) engines. SAE Paper 892068.
32. Yates, D.B., Swarts, A., and Viljoen, C.L. (2005) Correlating Auto-Ignition Delays and Knock Limited Spark-Advance Data for Different Types of Fuel. SAE Paper 2005-01-2083.
33. Yoshizawa, K., Teraji, A., Aochi, E., Kubo, M., and Kimura, S. (2002) Numerical Analysis of Combustion in Gasoline Compression Ignition Engines. SAE Paper 2002-01-2865.
34. Xu, H., Fu, H., Williams, H., and Shilling, I. (2002) Modeling Study of Combustion and Gas Exchange in a HCCI (CAI) engine. SAE Paper 2002-01-0114.