A new approach for the validation of filling simulations in micro injection moulding

AIP Conference Proceedings

Volumn 908, Issue , 2007, Pages 307-312

  Gava, A ^a   Tosello, G ^b   Hansen, H N ^b   Salvador, M ^a   Lucchetta, G ^a  

^a UNIVERSITY OF PADOVA   (Italy)

^b TECHNICAL UNIVERSITY OF DENMARK   (Denmark)

Author keywords

Filling simulation; Micro injection moulding; Weld lines

Indexed keywords

EID: 34547418069     PISSN: 0094243X     EISSN: 15517616     Source Type: Conference Proceeding    
DOI: 10.1063/1.2740829     Document Type: Conference Paper

References (7)

1. C. M. Ho and Y. C. Tay, "Micro-electro-mechanical-systems (MEMS) and fluid flows", Annu. Rev. Fluid Mech, 1998.
2. O. Kemmann, L. Weber, C. Jeggy, O. Magotte and F. Dupret, "Simulation of the micro injection moulding process", Proc. SPE ANTEC, 2000.
3. L. Yu, Experimental and numerical analysis of injection moulding with microfeatures, Ph.D. Thesis, Ohio University, p.192, 2004.
4. F. Ilinca, J.F. Hétu and A. Derdouri, "Numerical Simulation of the Filling Stage in the Micro-Injection Moulding Process", Antec, 2004.
5. L. Yu, C. G. Koh, L. J. Lee and K. W. Koelling, "Experimental Investigation and Numerical Simulation of Injection Moulding With Micro-Features", Polymer Engineering and Science 42, (2002).
6. P. Kennedy, Flow analysis of injection moulds, Hanser, 1995.
7. R. D. Chien, W. R. Jong and S. C. Chen, "Study on Rheological Behaviour Of Polymer Melt Flowing Through Micro-Channels", Journal of Micromechanics and Microengineering 15, pp. 1389-1396, (2005).