메뉴 건너뛰기




Volumn 48, Issue 22, 2007, Pages 3879-3882

Synthesis and self-assembly properties of a novel [poly(ethylene glycol)]-fluorocarbon-phospholipid triblock copolymer

Author keywords

[No Author keywords available]

Indexed keywords

[POLY (ETHYLENE GLYCOL)] FLUOROCARBON PHOSPHOLIPID TRIBLOCK COPOLYMER; COPOLYMER; PHOSPHOLIPID DERIVATIVE; PYRENE; UNCLASSIFIED DRUG;

EID: 34247616771     PISSN: 00404039     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.tetlet.2007.03.148     Document Type: Article
Times cited : (25)

References (23)
  • 1
    • 9944229543 scopus 로고    scopus 로고
    • Torchilin V.P. CMLS 61 (2004) 2549-2559
    • (2004) CMLS , vol.61 , pp. 2549-2559
    • Torchilin, V.P.1
  • 6
    • 34247624528 scopus 로고    scopus 로고
    • Gladysz J.A., Curran D.P., and Horvath I.T. (Eds), Wiley-VCH, Weinheim Chapter 12
    • Krafft M.P. In: Gladysz J.A., Curran D.P., and Horvath I.T. (Eds). Handbook of Fluorous Chemistry (2004), Wiley-VCH, Weinheim Chapter 12
    • (2004) Handbook of Fluorous Chemistry
    • Krafft, M.P.1
  • 7
    • 0007097372 scopus 로고    scopus 로고
    • Marcel Dekker, New York
    • Kissa E. Fluorinated Surfactants and Repellents. 2nd ed. Surfactant Science Series Vol. 97 (2001), Marcel Dekker, New York
    • (2001) Surfactant Science Series , vol.97
    • Kissa, E.1
  • 18
    • 34247639435 scopus 로고    scopus 로고
    • note
    • Preparation and characterization of compounds 1-6 are available as Supplementry data.
  • 20
    • 34247598292 scopus 로고    scopus 로고
    • note
    • The samples for DLS studies were prepared by dissolving 1 in dichloromethane and subsequently concentrating the solution in vacuo to give a thin film. This was reconstituted in water so that the concentration of the solution was 1.25 mg/mL. The solution was then sonicated for 15 min and allowed to equilibrate for 30 min. The solution was passed through a 0.20 mm filter directly into a quartz cuvette used for the measurements. The data were collected and analyzed in triplicate.
  • 23
    • 34247559656 scopus 로고    scopus 로고
    • note
    • The samples for CMC determination were prepared by first transferring a solution of pyrene in acetone (12 mL of a 100 mM solution) to clean, dry 2 dram vials. The acetone was removed in vacuo and solutions of polymer in water were added so that the final pyrene concentration was 0.5 mM. The vials were then heated to 70 °C with good stirring in an oil bath for 1.5 h, and then allowed to equilibrate at room temperature for 2 h with no stirring. The solutions were transferred directly to a clean, dry cuvette used for the measurements. Data for each concentration were obtained in triplicate, and the reported values are the average of these measurements.


* 이 정보는 Elsevier사의 SCOPUS DB에서 KISTI가 분석하여 추출한 것입니다.