Feasible design space for shell-and-tube heat exchangers using the bell - Delaware method

Industrial and Engineering Chemistry Research

Volumn 46, Issue 1, 2007, Pages 143-155

  Serna González, Medardo ^a   Ponce Ortega, José M ^a,b   Castro Montoya, Agustín J ^a   Jiménez Gutiérrez, Arturo ^b  

^a UNIVERSIDAD MICHOACANA DE SAN NICOLÁS DE HIDALGO   (Mexico)

^b DEPARTAMENTO DE INGENIERÍA QUÍMICA   (Mexico)

Author keywords

[No Author keywords available]

Indexed keywords

COMPUTATIONAL GEOMETRY; COMPUTER SOFTWARE; CONSTRAINT THEORY; HEAT TRANSFER COEFFICIENTS; MACHINE DESIGN; NUMERICAL METHODS;

COMPACT EQUATION; DELAWARE METHOD; KERN METHOD;

HEAT EXCHANGERS;

COMPUTATIONAL GEOMETRY; COMPUTER SOFTWARE; CONSTRAINT THEORY; HEAT EXCHANGERS; HEAT TRANSFER COEFFICIENTS; MACHINE DESIGN; NUMERICAL METHODS;

EID: 33846669545     PISSN: 08885885     EISSN: None     Source Type: Journal    
DOI: 10.1021/ie051371x     Document Type: Article

References (21)

1. Poddar, T. K.; Polley, G. T. Heat exchanger design through parameter plotting. Chem. Eng. Res. Des. 1996, 74, 849-852.
2. Poddar, T. K.; Polley, G. T. Optimize shell-and-tube heat exchanger design. Chem. Eng. Prog. 2000, September, 41-46.
3. Muralikrishna, K.; Shenoy, U. V. Heat exchanger design targets for minimum area and cost. Chem. Eng. Res. Des. 2000, 78, 161-167.
4. Kern, D. Q. Process Heat Transfer, McGraw-Hill: New York, 1950.
5. Taborek, J. Shell-and-tube heat exchangers: single-phase-flow. Heat Exchanger Design Handbook; Hemisphere Publishing Corp.: Bristol, PA, 1983; Vol. 3, Section 3.3.
6. Sieder, E. N.; Tate, G. E. Heat transfer and pressure drop of liquids in tubes. Ind. Eng. Chem. 1936, 28, 1429-1435.
7. McAdams, W. H. Heat Transmission; McGraw-Hill: New York, 1954.
8. Sinnott, R. K. An Introduction to Chemical Engineering Design; Chemical Engineering Series; Coulson, J. M., Richardson, J. F., Eds.; Pergamon Press: Oxford, U.K., 1989; Vol. 6.
9. Serna, M.; Jiménez, A. An efficient method for the design of shell and tube heat exchangers. Heat Transfer Eng. 2004, 25 (2), 5-16.
10. Tinker, T. Shell-side characteristics of shell and tube heat exchangers, Parts I, II, III. General Discussion on Heat Transfer; Inst. Mech. Eng.: London, 1951.
11. Tinker, T. Shell-side characteristics of shell and tube heat exchangers: A simplified rating system for commercial heat exchangers. Trans. ASME 1958, 80, 36-52.
12. Bell, K. J. Final Report of the Cooperative Research Program on Shell and Tube Heat Exchangers; Bulletin No. 5; University of Delaware, Engineering Experimental Station: Newark, DE, 1963.
13. Bell, K. J. Delaware method for the shell side design. In Heat Exchangers: Thermal-Hydraulic Fundamentals and Design; Kakac, S., Bergles, A. E., Mayinger, F., Eds.; Hemisphere: Washington, DC, 1981.
14. Palen, J. W.; Taborek, J. Solution of shell side flow pressure drop and heat transfer by stream analysis method. Chem. Eng. Prog. Symp. Ser. 1969, 65, 53-63.
15. Kakac, S.; Liu, H. Heat Exchangers - Selection, Rating, and Thermal Design, 2nd ed; CRC Press: Boca Raton, FL, 2002.
16. Serna-González, M.; Ponce-Ortega, J. M.; Castro-Montoya, A. J.; Jiménez-Gutiérrez, A. Design space of shell and tube heat exchangers by an improved method. Proceedings of 17th Internacional Conference on Efficiency, Costs, Optimization, Simulation and Environmental Impact of Energy and Process Systems (ECOS - 2004), Guanajuato, México, July 7-9, 2004; pp 865-873; ISBN-968-489-027-3.
17. Serna, M.; Jiménez, A Compact Bell-Delaware Formulation for Heat Exchanger Design and Optimization. Chem. Eng. Res. Des. 2005, 83, 539-550.
18. Eryener, D. Thermoeconomic Optimization of Baffle Spacing for Shell and Tube Heat Exchangers. Energy Convers. Manage. 2006, 47, 1478-1489.
19. Roque, M. C.; Lona, L. M. F. The Economics of the Detailed Design of Heat Exchanger Networks Using the Bell-Delaware Method. Comput Chem. Eng. 2000, 24, 1349-1353.
20. Ravagnani, M. S. S. S.; da Silva, A. P.; Andrade, A. L. Detailed Equipment Design in Heat Exchanger Network Synthesis and Optimization. Appl. Therm. Eng. 2003, 23, 141-151.
21. Mizutani, F. T.; Pessoa, F. L. P.; Queiroz, E. M.; Hauan, S.; Grossmann, I. E. Methematical Programming Model for Heat Exchanger Network Synthesis Including Detailed Heat-Exchanger Design. Ind. Eng. Chem. Res. 2003, 42, 4019-4027.