Application of factorial design for studying the burr behaviour during face milling of motor engine blocks

Journal of Materials Processing Technology

Volumn 179, Issue 1-3, 2006, Pages 154-160

  da Silva, Luiz Carlos ^a   de Melo, Anderson Clayton A ^b   Machado, Álisson Rocha ^c   da Silva, Marcio Bacci ^c   Júnior, Antônio Maria Souza ^d  

^a Centro Federal de Educacao Tecnologica de Goias   (Brazil)

^b Instituto Superior Tupy   (Brazil)

^c FEDERAL UNIVERSITY OF UBERLÂNDIA   (Brazil)

^d Fiat GM Powertrain   (Brazil)

Author keywords

Burr formation; Grey cast iron; Milling

Indexed keywords

CAST IRON; CERAMIC MATERIALS; MACHINE DESIGN; MILLING CUTTERS;

BURR FORMATION; GREY CAST IRON; MOTOR ENGINE BLOCKS;

MILLING (MACHINING);

EID: 33748628828     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jmatprotec.2006.03.097     Document Type: Article

References (8)

1. L.C. Silva, Estudo da Rebarba no Fresamento de Faceamento em Blocos de Motores de Ferro Fundido Cinzento Utilizando Insertos de Cerâmica e PCBN [Study of burr formation in face milling of gray cast iron motor engine blocks using inserts of ceramic and PCBN], M.Sc. Dissertation, Federal University of Uberlândia, Uberlândia, MG, Brazil, 176 pp., 2004 (in Portuguese).
2. Ko S.L., and Dornefeld D.A. A study on burr formation mechanism. J. Mater. Process. Technol. 113 (1991) 75-87
3. Gillespie L.K., and Blotter P.T. The formation and properties of machining burrs. Trans. ASME, J. Eng. Ind. February (1976) 66-74
4. Nakayama K., and Arai M. Burr formation in metal cutting. Ann. CIRP 36 (1987) 33-36
5. Gillespie L.K. Burr Produced by End-Milling. BDX-613-1503 (1976), Bendix Co. Kansas City Division
6. Kishimoto W., Miyake T., Yamamoto A., Yamanaka K., and Tacano K. Study of burr formation in face milling. Bull. Jpn. Soc. Prec. Eng. 15 1 (1981) 51-52
7. Olvera O., and Barrow G. An experimental study of burr formation in square shoulder face milling. Int. J. Mach. Tools Manuf. (1996) 1005-1020
8. Kaminise A.K., Gonçalves R.A., Machado A.R., and Da Silva M.B. Properties of burrs formed when cutting AISI 1045 carbon steel in turning operation. Proceeding of the 7th International Conference on Deburring and Surface Finishing. Berkeley, CA, USA, June 7-9 (2004) 127-135