An experimental study of burr formation in square shoulder face milling

International Journal of Machine Tools and Manufacture

Volumn 36, Issue 9, 1996, Pages 1005-1020

  Olvera, O ^a   Barrow, G ^a  

^a UNIVERSITY OF MANCHESTER   (United Kingdom)

Author keywords

[No Author keywords available]

Indexed keywords

COATINGS; CUTTING; CUTTING TOOLS; DEFECTS; VELOCITY;

AXIAL CUT DEPTH; BURR; EXIT ANGLE; FACE MILLING; FEED PER TOOTH; TOOL NOSE GEOMETRY;

MILLING (MACHINING);

EID: 0030241641     PISSN: 08906955     EISSN: None     Source Type: Journal    
DOI: 10.1016/0890-6955(96)00014-4     Document Type: Article

References (12)

1. L. K. Gillespie, The formation and properties of machining burrs. M.S. Thesis, Utah State University, Logan, UT (1973).
2. F. Schafer, Product design influences on deburring, SME Paper MR75-483 U.S.A. (1975).
3. L. K. Gillespie, Burrs produced by end-milling, Bendix Report BDX-613-1503 U.S.A. (1976).
4. L. K. Gillespie, Advances in deburring, SME, U.S.A. (1978), National Technical Information Service, U.S.A.
5. W. Kishimoto, T. Miyake and A. Yamamoto, Study of burr formation in face milling, Bull. Jap. Soc. Precision Engng 15, 51-52 (1981).
6. K. Nakayama and M. Arai, Burr formation in metal cutting, Ann. CIRP 36, 33-36 (1987).
7. S. L. Ko and D. A. Dornfeld, A study on burr formation mechanism, Symp. on Robotics, ASME DSC, ASME Winter Annual Meeting, New York. Vol. 11, p. 271 (1988).
8. S. L. Ko and D. A. Dornfeld, Analysis and modelling of burr formation and breakout in metal, Mechanics of Deburring and Surface finishing Processes (edited by R.J. Stango and P.R. Fitzpatrick), Vol. PED 38, p. 79. ASME, New York (1989).
9. K. Kitajima, T. Miyake, A. Yamamoto, Y. Tanaka and K. Takazawa, Study on mechanism and similarity of burr formation in face milling and drilling, Technical reports, Vol. 32, p. 1., Kansai University (1990).
10. G. L. Chern, Analysis of buff formation and breakout in metal cutting. Ph.D. Thesis, University of California, Berkeley, CA (1993).
11. W. Konig, Minimizing burr formation, Presentation at the CIRP STC "C" meeting, Edinburgh, August (1993) (unpublished).
12. R. Narayanaswami and D. A. Dornfeld, Design and process planning strategies for burr minimization and deburring, Trans. NAMRI/SME 22, 313 (1994).