Optical method for accurate force measurement: Dynamic response evaluation of an impact hammer

Optical Engineering

Volumn 45, Issue 2, 2006, Pages

  Fujii, Yusaku ^a  

^a GUNMA UNIVERSITY   (Japan)

Author keywords

Dynamic calibration; Dynamic force; Force sensor; Inertial force; Inertial mass; Optical interferometer; Pneumatic linear bearing

Indexed keywords

DOPPLER EFFECT; DYNAMIC RESPONSE; FORCE MEASUREMENT; INTERFEROMETERS; LASER BEAMS; PNEUMATIC EQUIPMENT; PRESSURE TRANSDUCERS;

DOPPLER FREQUENCY SHIFT; PNEUMATIC LINEAR BEARING;

OPTICAL ENGINEERING;

EID: 33748616238     PISSN: 00913286     EISSN: 15602303     Source Type: Journal    
DOI: 10.1117/1.2170713     Document Type: Article

References (14)

1. Y. Fujii and H. Fujimoto, "Proposal for an impulse response evaluation method for force transducers," Meas. Sci. Technol. 10, N31-33 (1999).
2. Y. Fujii, "Measurement of impulse response of force transducers," Rev. Sci. Instrum. 72, 3108-3111 (2001).
3. Y. Fujii, "A method for calibrating force transducers against oscillation force," Meas. Sci. Technol. 14(8), 1259-1264 (2003).
4. Y. Fujii, "Proposal for a step response evaluation method for force transducers," Meas. Sci. Technol. 14(10), 1741-1746 (2003).
5. Y. Fujii and T. Yamaguchi, "Method for evaluating material viscoelasticity," Rev. Sci. Instrum. 75(1), 119-123 (2004).
6. T. Bruns and M. Kobusch, "Impulse force calibration: design and simulation of a new calibration device," in Proc. 17th IMEK0 TC3 Conf., pp. 85-91, Istanbul, Turkey (2001).
7. Y. Fujii, "Measurement of force acting on a moving part of a pneumatic linear beating," Rev. Sci. Instrum. 74(6), 3137-3141 (2003).
8. R. Kumme, "Investigation of the comparison method for the dynamic calibration of force transducers," Measurement 23, 239-245 (1998).
9. R. Kumme and M. Dixon, "The results of comparisons between two different dynamic force measurement systems," Measurement 10, 140-144 (1992).
10. Y.-K. Park, R. Kumme, and D.-I. Kang, "Dynamic investigation of a three-component force-moment sensor," Meas. Sci. Technol. 13, 654-659 (2002).
11. Y.-K. Park, R. Kumme, and D.-I. Kang, "Dynamic investigation of a binocular six-component force-moment sensor," Meas. Sci. Technol. 13, 1311-1318 (2002).
12. Y. F. Li and X. B. Chen, "On the dynamic behavior of a force/torque sensor for robots," IEEE Trans. Instrum. Meas. 47, 304-308 (1998).
13. K.-J. Xu and C. Li, "One-stage identification algorithm and two-step compensation method of Hammerstein model with application to wrist force sensor," Rev. Sci. Instrum. 73, 1949-1955 (2002).
14. International Organization for Standardization, Guide to the Expression of Uncertainty in Measurement, Geneva (1993).