The study of the water assisted injection molding process

Annual Technical Conference - ANTEC, Conference Proceedings

Volumn 3, Issue , 2006, Pages 1200-1204

  Hwang, Shyh Shin ^a   Hsu, Pei Min ^b   Pan, Zhong Min ^a  

^a CHING YUN UNIVERSITY   (Taiwan)

^b FAR EAST UNIVERSITY   (Taiwan)

Author keywords

Gas Assisted Injection Molding(GAIM); Injection molding; Water Assisted Injection Molding (WAIM)

Indexed keywords

ABS RESINS; CRYSTALLINE MATERIALS; NITROGEN; POLYPROPYLENES; WATER;

GAS-ASSISTED INJECTION MOLDING(GAIM); WATER PRESSURE; WATER TEMPERATURE; WATER-ASSISTED INJECTION MOLDING (WAIM);

INJECTION MOLDING;

EID: 33745594631     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (8)

1. S. C. Chen, K. S. Hsu and I. S. Huang, "Analysis and Experimental Study of Gas Penetration in a Gas-Assisted Injection Molded Spiral Tube", J. of Applied Polymer Science, 58, p. 793-799 (1995).
2. J. W. Shin and A. I. Isayev, "Experimental study of gas penetrating in gas-assisted injection molding", J. of Injection Molding Technology, Vol. 6, No. 4, p. 314-329, (2002).
3. X. Lu, H. H. Chiang, J. Zhao, and S. C. Chen, "Study of "gas fingering" behavior in gas-assisted injection molding", Poly Eng. and Sci. Vol. 39, No. 1, p. 62-77 (1999)
4. L. S. Turng, "Special and emerging injection molding processes", J. of Injection Molding Technology, Vol. 5, No. 3, p. 160-179, (2001)
5. W. Michaeli, A. Brunswick, and Tim Pohl, "A comparison of gas and water injection molding of hollow articles by fluid-assisted injection", Kunststoff plast Europe, Vol. 89, No. 9, p. 18-20 (1999)
6. W. Michaeli, A. Brunswick, and C. Kujat, "Reducing cooling time with water-assisted injection molding: Advantages over gas-assisted injection", Kunststoff plast Europe, Vol. 90, No. 8, p. 25-28 (2000).
7. T. Juntgen, W. Michaeli, 'The Water Injection Technique(WIT) as an attractive alternative and supplement to gas-assisted injection molding", ANTEC Technical paper, (2002)
8. S. J. Liu and Y. S. Chen, "Water-assisted Injection Molding of Thermoplastic: Effect of Processing Parameters", Poly. Eng. and Sci. Vol. 43, No. 11, p. 1806-1817 (2003).