Water-Assisted Injection Molding of Thermoplastic Materials: Effects of Processing Parameters

Polymer Engineering and Science

Volumn 43, Issue 11, 2003, Pages 1806-1817

  Liu, Shih Jung ^a   Chen, Yen Show ^a  

^a CHANG GUNG UNIVERSITY   (Taiwan)

Author keywords

[No Author keywords available]

Indexed keywords

INJECTION MOLDING; PARAMETER ESTIMATION; POLYMERS; PROCESS CONTROL; PUMPS; RECYCLING; VOLUMETRIC ANALYSIS; WATER INJECTION;

CONTROL CIRCUIT; GAS-ASSISTED INJECTION MOLDING;

THERMOPLASTICS;

EID: 1542605248     PISSN: 00323888     EISSN: None     Source Type: Journal    
DOI: 10.1002/pen.10153     Document Type: Article

References (12)

1. M. Knights, Plast. Technol., April, 42 (2002).
2. W. Michaeli, A. Brunswick, and T. Pohl, Kunststoff plast europe, 89, 18 (1999).
3. W. Michaeli, A. Brunswick, and M. Gruber, Kunststoff plast europe, 89, 20 (1999).
4. W. Michaeli, A. Brunswick, and C. Kujat, Kunststoff plast europe, 90, 25 (2000).
5. W. Michaeli, T. Juntgen, and A. Brunswick, Kunststoff plast europe, 91, 37 (2001).
6. S. J. Liu, J. H. Chang, C. Y. Ho, and S. W. Hung, Inter. Polym. Process., 14, 191 (1999).
7. S. J. Liu and J. H. Chang, Polym. Comp., 21, 322 (2000).
8. S. J. Liu and Y. C. Wu, Inter. Polym. Process., 15, 297 (2000).
9. S. J. Liu and C. Y. Yang, Plast. Rubber Comp., 31, 36 (2002).
10. S. J. Liu and I. H. Lin, Plast. Rubber Comp., 31, 28 (2002).
11. H. Potente, E. Moritzer, and C. H. Oberman, Polym. Eng. Sci., 36, 2163 (1996).
12. Y. S. Chen, Master Thesis, Chang Gung University, Taiwan (2002).