Injection molding of microprobe array parts

Journal of Polymer Research

Volumn 13, Issue 1, 2006, Pages 25-32

  Chang, Pei Chi ^a   Hwang, Sheng Jye ^a  

^a NATIONAL CHENG KUNG UNIVERSITY   (Taiwan)

Author keywords

Electroforming; Injection molding; KOH etching; Microprobe

Indexed keywords

ARRAYS; BIOLOGICAL ORGANS; CELLS; ELECTROFORMING; ENDOSCOPY; SILICON; SINGLE CRYSTALS; STAINLESS STEEL; TUMORS;

KOH ETCHING; MICROPROBE; OPTIMAL PROCESSING PARAMETERS; TAGUCHI METHOD;

INJECTION MOLDING;

EID: 30844462118     PISSN: 10229760     EISSN: None     Source Type: Journal    
DOI: 10.1007/s10965-005-9006-x     Document Type: Article

References (9)

1. M. L. Reed, Micromechanical devices for intravascular drug delivery, J. Pharm. Sci., 87 (11), 1387 (1998).
2. M. S. Despa, K. W. Kelly and L. R. Collier, Injection molding of polymeric LIGA HARMs, Microsyst, Technol., 6, 60, (1999).
3. O. Kemmann and L. Weber, Micro moulding behaviour of engineering plastics, Proc. SPIE Int. Sac. Opt. Eng., 3680 (I), 464-471, (1999).
4. L. Yu, Y.-L. Juang, K. W. Koelling and L. J. Lee, Flow and heat transfer simulation of thin-wall injection molding with microstructures, ANTEC, Conference Proceedings, 1, 602-606 (2003).
5. M. Niggemann, W. Etrfeld and L. Weber, Miniaturized plastic micro plates for applications in HTS, Microsyst. Technol., 6, 48 (1999).
6. Y.-C. Su, J. Shah and L. Lin, Implementation and analysis of polymeric microstructure replication by micro injection molding, J. Micromechanics Microengineering, 14, 415 (2004).
7. R. Divan, H. Camon, N. Moldovan and M. Dilhan, Limiting roughness in anisotropic etching, IEEE, (1997).
8. M. Madou, Fundamentals of Microfabrication, CRC, New York, 1997.
9. O. Dorsch, A. Hein and E. Obermeier, Effect of the Silicon Content of Aqueous KOH on the Etching Behavior of Convex Corners in