Error measurements for flank milling

CAD Computer Aided Design

Volumn 37, Issue 14, 2005, Pages 1459-1468

  Li, Chenggang ^a   Mann, Stephen ^a   Bedi, Sanjeev ^a  

^a UNIVERSITY OF WATERLOO   (Canada)

Author keywords

Error metric; Five axis machining; Optimization

Indexed keywords

APPROXIMATION THEORY; ERROR ANALYSIS; MILLING (MACHINING); OPTIMIZATION;

ERROR ASSESSMENT; ERROR METRIC; FIVE-AXIS MACHINING; MACHINE RULED SURFACES;

COMPUTER AIDED DESIGN;

EID: 24344440271     PISSN: 00104485     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.cad.2005.02.014     Document Type: Article

References (12)

1. S. Bedi, S. Mann, and C. Menzel Flank milling with flat end cutters Comput Aided Des 35 2003 293 300
2. F. Rehsteiner, and H.J. Renker Collision-free five-axis milling of twisted ruled surfaces CIRP Ann 42 1 1993 457 461
3. G. Stute, A. Storr, and W. Sielaff Nc programming of ruled surface for five axis machining Ann CIRP 28 1 1979 267 271
4. X. Liu Five-axis NC cylindrical milling of sculptured surfaces Comput Aided Des 27 12 1995 887 894
5. E.L.J. Bohez, S.D.R. Senadhera, K. Pole, J.R. Duflou, and T. Tar A geometric modelling and five-axis machining algorithm for centrifugal impellers J Manuf Syst 16 6 1997 422 463
6. D.M. Tsay, and M.J. Her Accurate 5-axis machining of twisted ruled surfaces J Manuf Sci Eng 123 2001 734 738
7. J.-M. Redonnet, W. Rubio, and G. Dessein Side milling of ruled surfaces: optimum positioning of the milling cutter and calculation of interference Adv Manuf Technol 14 7 1998 459 465
8. F. Monies, J.-M. Redonnet, W. Rubio, and P. Lagarrigue Improved position of a conical mill for machining ruled surfaces: application to turbine blades J Eng Manuf 214(B) 2000 625 634
9. F. Monies, W. Rubio, J.-M. Redonnet, and P. Lagarrigue Comparative study of interference caused by different position settings of a conical milling cutter on a ruled surface Proc Inst Mech Eng B J Eng Manuf 215 9 2001 1305
10. F. Monies, J.N. Felices, W. Rubio, J.-M. Redonnet, and P. Lagarrigue Five-axis nc milling of ruled surface: optimal geometry of a conical tool Int J Prod Res 40 12 2002 2901 2922
11. C. Menzel, S. Bedi, and S. Mann Triple tangent flank milling of ruled surface Comput Aided Des 2004 36
12. Chenggang Li. Flank milling of ruled surfaces with conical tools. Master's Thesis, University of Waterloo; 2004.