Durability of an off-optimum cured aluminium joint

International Journal of Adhesion and Adhesives

Volumn 24, Issue 2, 2004, Pages 95-106

  Rider, Andrew ^a   Chalkley, Peter ^b  

^a DEFENCE SCIENCE AND TECHNOLOGY ORGANISATION   (Australia)

^b NATIONAL UNIVERSITY OF IRELAND   (Ireland)

Author keywords

A: Primers and coupling agents; B: Aluminium and alloys; C. X ray photoelectron spectroscopy; C: Wedge tests; D: Durability

Indexed keywords

ADHESIVE JOINTS; ALUMINUM ALLOYS; BONDING; CANTILEVER BEAMS; CURING; DEGRADATION; DURABILITY; ENERGY DISSIPATION; FRACTURE; INTERFACES (MATERIALS); MOISTURE; SCANNING ELECTRON MICROSCOPY; SILANES; STRONTIUM COMPOUNDS; THERMAL STRESS; X RAY PHOTOELECTRON SPECTROSCOPY;

FILM ADHESIVES; PRIMERS; WEDGE TESTS;

ADHESION;

EID: 1642560569     PISSN: 01437496     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0143-7496(03)00102-7     Document Type: Article

References (24)

1. Critchlow G.W., Brewis D.M. Review of surface pretreatments for aluminium alloys. Int J Adhes Adhes. 16:1996;255-275.
2. Rider A.N., Arnott D.R. Boiling water and silane pre-treatment of aluminium alloys for durable adhesive bonding. Int J Adhes Adhes. 20:2000;209.
3. Crook R.A., Laheru K.L., Sinclair J.W. The use of surface preparations and fillers in the promotion of cohesive failure of EA946/aluminium bondlines. Surf Coat J. 140:2001;1-10.
4. Baker AA, Jones R, editors. Bonded repair of aircraft structures. Dordrecht: Martinus Nijhoff Publishers; 1988.
5. Baker A.A., Chester R.J. Minimum surface treatments for adhesively bonded repairs. Int J Adhes Adhes. 12:1992;73-78.
6. Digby R.P., Shaw S.J. The international collaboration programme on organosilane coupling agents. an introduction Int J Adhes Adhes. 18:1998;261-264.
7. Rattana A., Herme J.D., Abel M-.L., Watts J.F. The interaction of a commercial dry film adhesive with aluminium. a study by XPS and ToF-SIMS Int J Adhes Adhes. 22:2002;205-218.
8. Fernandes J.C.S., Ferreira M.G.S., Haddow D.B., Goruppa A., Short R., Dixon D.G. Plasma-polymerised coatings used as pre-treatments for aluminium alloys. Surf Coat J. 154:2002;8-13.
9. Pearce P., Ennis B.C., Grabovac I., Morris C.E.M. Off-optimum cure of aerospace epoxy adhesives. J Adhes. 47:1994;123-132.
10. ASTM, Annual Book of Standards, Section 15, vol. 15.06, Adhesives. Philadelphia: ASTM, 1995-ASTM D3433, Fracture strength in cleavage of adhesives in bonded joints.
11. ASTM, Annual Book of Standards, Section 15, vol. 15.06, Adhesives. Philadelphia: ASTM, 1995-ASTM D3762, Adhesive bonded surface durability of aluminium.
12. Boeing Aircraft Company. Specification for adhesive joint durability testing, BSS 7208.
13. Stone MH, Peet T. Evaluation of the wedge test for assessment of durability of adhesive bonded joints. Royal Aircraft Establishment, Technical Memorandum, Mat 349, July 1980.
14. Chalkley PD. A critical compendium of material property data for bonded composite repairs. Divisional Discussion Paper, DSTO-DDP-0274, DSTO, 1997.
15. Rider A.N., Olsson-Jacques C.L., Arnott D.R. Influence of adherend surface preparation on bond durability. Surf Interface Anal. 27:1999;1055.
16. Rider AN. Factors influencing the durability of epoxy adhesion to silane pretreated aluminium. Int J Adhes Adhes, in press.
17. Morris C.E.M., Pearce P.J., Davidson R.G. Characterisation of two nitrile-epoxy structural adhesives. J. Adhes. 15(1):1982;1.
18. Zin I.M., Howard R.L., Badger S.J., Scantlebury J.D., Lyon S.B. The mode of action of chromate inhibitor in epoxy primer on galvanised steel. Prog Org Coat. 33:1998;203.
19. Libera M., Zukas M., Wentworth S., Patel A. Polym/Inorg Interfaces II Mater Res Soc Symp Proc. 385:1995;65.
20. Arayasantiparb D., McKnight S., Libera M. Compositional variation within the epoxy/adherend interphase. J Adhes Sci Technol. 15:2001;1463.
21. Bockenheimer C., Valeske B., Possart W. Network structure in epoxy aluminium bonds after mechanical treatment. Int J Adhes Adhes. 22(5):2002;349.
22. Bouchet J., Roche A.A., Jacquelin E. How do residual stresses and the interphase mechanical properties affect practical adhesion of epoxy/diamine metallic substrate systems? J Adhes Sci Technol. 16(12):2002;1603.
23. Pearce P.J., Arnott D.R., Camilleri A., Kindermann M.R., Mathys G.I., Wilson A.R. Cause and effect of void formation during vacuum bag curing of epoxy film adhesives. J Adhes Sci Technol. 12(6):1998;567.
24. Voyutskii S.S. Autohesion and adhesion of high polymers. 1963;Wiley Interscience, New York.