The effect of argon-enriched environment in high-speed machining of titanium alloy

Tribology Transactions

Volumn 48, Issue 1, 2005, Pages 18-23

  Ezugwu, E O ^a   Da Silva, R B ^a   Bonney, J ^a   Machado, A R ^b  

^a Faculty of Engineering   (United Kingdom)

^b FEDERAL UNIVERSITY OF UBERLÂNDIA   (Brazil)

Author keywords

Argon gas; Carbide tools; Cutting forces; Higher cutting conditions; Titanium alloy; Tool wear

Indexed keywords

ARGON; COOLANTS; CUTTING TOOLS; FAILURE ANALYSIS; MACHINING; SPEED; WEAR RESISTANCE; LUBRICATION; PHASE INTERFACES; REACTION KINETICS;

ARGON-ENRICHED ENVIRONMENT; HIGH-SPEED MACHINING; TOOL-FAILURE MODE; TOOL-WORKPIECE; ARGON GAS; CUTTING FORCES; HIGHER CUTTING CONDITIONS; TOOL WEAR;

TITANIUM ALLOYS;

TOOL WEAR;

EID: 13844313435     PISSN: 10402004     EISSN: None     Source Type: Journal    
DOI: 10.1080/05698190590890290     Document Type: Article

References (13)

1. SECO (2002), Turning Difficult-To-Machine Alloys, Technical Guide, p. 21.
2. Boyer, R. R. (1996), "An Overview on the Use of Titanium in the Aerospace Industry," Mat. Sci. Eng., A213, pp 103-114.
3. Ezugwu, E. O. and Wang, Z. M. (1997), "Titanium Alloys and Their Machinability - A Review," J. Mat. Process. Technol., 68, pp 262-274.
4. Miller, S. (1996), "Advanced Materials Mean Advanced Engines," Inst. Mat. Interdisc. Sci. Rev., 21(2), pp 117-129.
5. Vigneau, J. (1997), "Cutting Materials for Machining Superalloys," International CIRP/VDI Conference on Cutting Materials and Tooling, Dusseldorf, Germany, 19-20 September.
6. Gatto, A. and Iuliano, L. (1997), "Advanced Coated Ceramic Tools for Machining Superalloys," Int. J. Mach. Tools Manuf., 37(5), pp 591-605.
7. North, B. (1986), "Ceramic Cutting Tools," SME Technical Paper MR 86-451, SME, Dearborn, MI.
8. Okeke, C. I. (1999), "Threading and Turning of Aerospace Materials with Coated Carbide Inserts," Ph.D. Thesis, South Bank University, London, UK, p 247.
9. Mishina, H. (1992), "Atmospheric Characteristics in Friction and Wear of Metals," Wear, 152, pp 99-110.
10. Jawaid, A. (1982), "Syalon Ceramics in Metal Cutting," Ph.D. Thesis, University of Warwick, p 149.
11. Khamsehzadeh, H. (1991), "Behaviour of Ceramic Cutting Tools When Machining Superalloys," Ph.D. Thesis, University of Warwick, p 239.
12. Li, X. S. and Low, I. M. (1994), "Cutting Forces of Ceramic Cutting Tools," Key Engineering Materials, 96, pp 81-136.
13. Zhan, G., Mitomo, M., Xie, R. and Kurashima, K. (2000), "The Deformation Mechanisms of Superplastic Flow in Fine-Grained Beta-Silicon Nitride Ceramics," Acta Mater., 48, pp 2373-2382.