Tribological properties of dimpled silicon nitride under oil lubrication

Journal of the European Ceramic Society

Volumn 24, Issue 2, 2004, Pages 369-373

  Uehara, Y ^a   Wakuda, M ^b   Yamauchi, Y ^c   Kanzaki, S ^c   Sakaguchi, S ^c  

^a Fine Ceramics Research Association   (Japan)

^b NISSAN MOTOR CO   (Japan)

^c NATIONAL INSTITUTE OF ADVANCED INDUSTRIAL SCIENCE AND TECHNOLOGY AIST   (Japan)

Author keywords

Engine components; Finishing; Friction reduction; Lubrication; Si3N4; Surfaces; Wear

Indexed keywords

ABRASIVES; FRICTION; LUBRICATING OILS; LUBRICATION; TRIBOLOGY;

DIMPLED SURFACES;

SILICON NITRIDE;

ENGINE; FRICTION; MACHINE ELEMENT; OIL LUBRICATION; SILICON NITRIDE; TRIBOLOGY;

EID: 0346093560     PISSN: 09552219     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0955-2219(03)00220-6     Document Type: Article

References (9)

1. Kitamura, K., Takebayashi, H., Ikeda, M. and Percoulis, H.M., Development of ceramic cam roller follower for engine application, SAE Tech. Paper, 1997, 972774.
2. Kato, A. and Yasuda, Y. An analysis of friction reduction techniques for the direct-acting valve train system of a new-generation lightweight 3-liter V6 Nissan engine, SAE Tech. Paper, 1994, 940992.
3. Wong H.C. Umehara N. Kato K. The effect of surface roughness on friction of ceramics sliding in water Wear 218 2001 237-243
4. Blatter A. Maillat M. Pimenov S.M. Shafeev G.A. Simakin A.V. Loubnin E.N. Lubricated sliding performance of laser-patterned sapphire Wear 232 1999 226-230
5. Ronen A. Etsion I. Kligerman Y. Friction reducing surface-texturing in reciprocating automotive components Tribol. Trans. 44 3 2001 359-366
6. Tejima Y. Ishiyama A. Ura A. The influence of pores at sliding faces and the pores diameter on mechincal seals performance (in Japanese) J. Jpn. SOC Tribologis. 44 6 1999 444-451
7. Tejima Y. Ishiyama A. Ura A. The influence of rounded pores' diameter and depth at sliding faces for coefficient of friction under oil lubrication (in Japanese) J. Jpn. SOC Tribologis. 44 10 1999 816-823
8. Wakuda M. Yamauchi Y. Kanzaki S. Effect of workpiece properties on machinability in abrasive jet machining of ceramic materials Precision Eng. 26 2002 193-198
9. Wakuda M. Yamauchi Y. Kanzaki S. Influence of micromachining on strength degradation of silicon nitride ceramic J. Manuf. Eng. 216 B1 2002 55-60