Economic drilling conditions for a given deburring radius

Journal of Materials Processing Technology

Volumn 110, Issue 2, 2001, Pages 197-205

  Abdel Mohsen Mahdy, M ^a  

^a Ain Shams University   (Egypt)

Author keywords

[No Author keywords available]

Indexed keywords

AIRCRAFT ENGINE MANUFACTURE; ELECTROFORMING; OPTIMIZATION;

HOLE-EDGE;

DEBURRING;

EID: 0343832237     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0924-0136(00)00876-1     Document Type: Article

References (13)

1. Adachi, et al., A study on burr in low frequency vibratory drilling, in: Proceedings of the Fifth International Conference on Production Engineering, Tokyo, 1984, pp. 246-251.
2. Nakayama K. Burr formation in metal cutting. Ann. CIRP. 36(1):1987;33-36.
3. A. Welte, Electrochemical deburring (ECD) of intersecting holes in aircraft engine components - reliable and cost saving technology, SME Technical Paper Series No. 79-736, Michigan, 1979.
4. D.W. Sickels, Electrochemical deburring - some capabilities and limitations, SME MR 76-133, Michigan, 1976.
5. M.A. El Hakim, M. Abdel Mohsen, M. Abd Allah, Factors affecting burr height in drilling, in: Proceedings of the Third Conference on Applied Mechanical Engineering, Military Technical College, Egypt, April 12-14, 1988.
6. M.A. El Hakim, Factors affecting the surface roughness of machined steel, Bulletin No. 12, Faculty of Engineering, Ain Shams University, Cairo, 1981.
7. Pande S.S., Relekar H.P. Investigation on reducing burr formation in drilling. Int. J. Mech. Tool Des. 26(3):1986;339-346.
8. Stein J., Dornfeld D. Burr formation in drilling miniature holes. Ann. CIRP. 46(1):1997;63-66.
9. M. Abd Allah, Factors affecting electrochemical deburring (ECD) of machined holes, M.Sc. Thesis, Faculty of Engineering, Ain Shams University, Cairo, 1990.
10. El Hakim M.A., El Awam A.M., El Sabbagh A.S. A Computer program for the optimization of the machining variables. Comput. Ind. Eng. 7(4):1983;317-336.
11. M.A. El Hakim, M. Abdel Mohsen, M. Abdullah, Factors affecting electrochemical deburring (ECD) of machined holes, in: Proceedings of the AME Fourth Conference, Military Technical College, Cairo, May 5-7, 1990.
12. M. El Hakim, An algorithm for the determination of the optimum machining variables in turning, in: Proceedings of the International Computer Technology Conference of ASME Century 2, San Francisco, CA, August 12-15, 1980.
13. M.Y.M. Afifi, M.A. El Hakim, M. Adel Mohsen, Assessment of machine tool stability from Chatter data of workpiece materials, Bulletin of the Faculty of Engineering, Ain Shams University, Egypt, 1981.