A theoretical analysis of mechanical dissipation of an electroded quartz resonator

IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control

Volumn 50, Issue 8, 2003, Pages 1069-1072

  Lu, Pin ^a,b   Shen, Feng ^a   Chen, Haibo ^b  

^a INSTITUTE OF HIGH PERFORMANCE COMPUTING   (Singapore)

^b UNIVERSITY OF SCIENCE AND TECHNOLOGY OF CHINA   (China)

Author keywords

[No Author keywords available]

Indexed keywords

DAMPING; ELECTRODES; ENERGY DISSIPATION; NUMERICAL METHODS; SURFACES;

AT CUT QUARTS CRYSTAL MICROBALANCE; ELECTRODED QUARTZ RESONATOR; SURFACE DAMPING; THICKNESS SHEAR MODE;

RESONATORS;

EID: 0142009697     PISSN: 08853010     EISSN: None     Source Type: Journal    
DOI: 10.1109/TUFFC.2003.1226552     Document Type: Letter

References (16)

1. C. Lu and A. W. Czanderna, Eds. Applications of Piezoelectric Quartz Crystal Microbalances. Amsterdam: Elsevier, 1984.
2. M. Rodahl, F. Hook, A. Krozer, P. Brzezinksi, and B. Kasemo, "Quartz crystal microbalance setup for frequency and Q-factor measurements in gaseous and liquid environments," Rev. Sci. Instrum., vol. 66, no. 7, pp. 3924-3930, 1995.
3. A. Arnau, Y. Jimenez, and T. Sogorb, "An extended Butterworth-Van Dyke model for quartz crystal microbalance applications in viscoelastic fluid media," IEEE Trans. Ultrason., Ferroelect., Freq. Contr., vol. 48, no. 5, pp. 1367-1382, 2001.
4. B. Zimmermann, R. Lucklum, P. Hauptmann, J. Rabe, and S. Buttgenbach, "Electrical characterisation of high-frequency thickness-shear-mode resonators by impedance analysis," Sens. Actuators B, vol. 76, pp. 47-57, 2001.
5. A. Ballato, J. Kelly, J. Ballato, and A. Safari, "Dissipation in ceramic resonators and transducers," in Proc. IEEE Int. Freq. Contr. Symp., 1996, pp. 371-378.
6. J. Kelly, A. Ballato, and A. Safari, "Characterization of loss mechanisms in piezoelectric ceramic microresonators," in Proc. IEEE Ultrason. Symp., 1996, pp. 539-532.
7. J. Kelly, A. Ballato, and A. Safari, "The effect of a complex piezoelectric coupling coefficient on the resonance and antiresonance frequencies of piezoelectric ceramics," in Proc. IEEE Int. Symp. Applications Ferroelect., 1996, pp. 825-828.
8. S. Sherrit and B. K. Mukherjee, "The use of complex material constants to model the dynamic response of piezoelectric materials," in Proc. IEEE Ultrason. Symp., 1998, pp. 633-640.
9. P. C. Y. Lee, N. H. Liu, and A. Ballato, "Thickness vibrations of piezoelectric plates with dissipation," in Proc. IEEE Ultrason. Symp., 1999, pp. 869-872.
10. J. Zelenka, Piezoelectric Resonators and Their Applications. Amsterdam: Elsevier, 1986.
11. T. Ikeda, Fundamentals of Piezoelectricity. New York: Oxford University Press, 1990, ch. 6, pp. 119-137.
12. K. Y. Yasumura, T. D. Stowe, E. M. Chow, T. Pfafman, T. W. Kenny, B. C. Stipe, and D. Rugar, "Quality factors in micro- and submicron-thick cantilevers," IEEE J. Microelectromech. Syst., vol. 9, pp. 117-125, 2000.
13. R. D. Mindlin and W. J. Spencer, "Anharmonic, thickness-twist overtones of thickness-shear and flexural vibrations of rectangular, AT-cut quartz plates," J. Acoust. Soc. Amer., vol. 42, no. 6, pp. 1268-1277, 1967.
14. V. E. Bottonm Introduction to Quartz Crystal Unit Design. New York: Van Nostrand Reinhold, 1982, pp. 82-100.
15. W. Shockley, D. R. Curran, and D. J. Koneval, "Trapped-energy modes in quartz filter crystals," J. Acoust. Soc. Amer., vol. 41, pp. 981-993, 1967.
16. P. Lu, F. Shen, S. J. O'Shea, K. H. Lee, and T. Y. Ng, "Analysis of surface effects on mechanical properties of microcantilevers," Mater. Phys. Mechan., vol. 4, pp. 51-55, 2001.