Parameters affecting the full-shot molding of gas-assisted injection-molded parts

Advances in Polymer Technology

Volumn 22, Issue 1, 2003, Pages 1-14

  Liu, Shih Jung ^a   Chang, Kuang Huei ^a  

^a CHANG GUNG UNIVERSITY   (Taiwan)

Author keywords

Full shot gas assisted injection molding; Moldability; Numerical analysis; Processing parameters; Sink mark; Switchover mark

Indexed keywords

NUMERICAL ANALYSIS; POLYPROPYLENES; POLYSTYRENES; TEMPERATURE DISTRIBUTION;

FULL-SHOT GAS ASSISTED INJECTION MOLDING; GAS PENETRATION; MOLDABILITY; THERMAL CONTRACTION MODEL;

INJECTION MOLDING;

EID: 0037367570     PISSN: 07306679     EISSN: None     Source Type: Journal    
DOI: 10.1002/adv.10036     Document Type: Article

References (11)

1. Shah, S. SPE-ANTEC Tech Paper 1991, 37, 1494.
2. Becker, O.; Karsono, D.; Koelling, K.; Atlan, T. SPE-ANTEC Tech Paper 1997, 42, 615.
3. Turng, L. S. Adv Polym Tech 1995, 14, 1.
4. Poslinski, A. J.; Oehler, P. R.; Stokes, V. K. Polym Eng Sci 1995, 35, 877.
5. Chen, S. C.; Hsu, K. F.; Hsu, K. S. Num Heat Trans 1995, 28, 121.
6. Liu, S. J.; Chang, J. H.; Ho, C. Y.; Hung, S. W. Int Polym Proc 1999, 14, 191.
7. Liu, S. J.; Chang, J. H. Polym Comp 2000, 21, 322.
8. Liu, S. J.; Wu, Y. C. Int Polym Proc 2000, 15, 297.
9. Rosato, D. V.; Rosato, D. V. Plastics Processing Data Handbook; Van Nostrand Reinhold: New York, 1990.
10. Chang, K. H. Master's Thesis, Chang Gung University, Tao-Yuan, Taiwan, 2001.
11. Modern Plastic Encyclopedia; McGraw-Hill: New York, 1992.