An approximate amplitude attenuation correction for hot-film shear stress sensors

Experiments in Fluids

Volumn 34, Issue 2, 2003, Pages 285-290

  Kunkel, G J ^a   Marusic, I ^a  

^a University of Minnesota   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

BOUNDARY LAYERS; CALIBRATION; COMPUTER SIMULATION; CORRELATION METHODS; FRICTION; SENSORS; SHEAR STRESS;

HOT-FILM SENSORS;

FLUID DYNAMICS;

FILM;

EID: 0037297219     PISSN: 07234864     EISSN: None     Source Type: Journal    
DOI: 10.1007/s00348-002-0558-9     Document Type: Article

References (22)

1. Alfredsson PH, Johansson AV, Haritonidis JH, Eckelmann H (1988) The fluctuating wall-shear stress and the velocity field in the viscous sublayer. Phys Fluids 31:1026-1033
2. Bellhouse BJ, Schultz DL (1967) The determination of fluctuating velocity in air with heated thin-film gauges. J Fluid Mech 29:289-295
3. Bellhouse BJ, Schultz DL (1968) The measurement of fluctuating skin friction in air with heated thin-film gauges. J Fluid Mech 32:675-680
4. Breuer KS (1995) Stochastic calibration of sensors in turbulent flow fields. Exp Fluids 19:138-141
5. Brown GL, Thomas ASW (1977) Large structure in a turbulent boundary layer. Phys Fluids 20:S243-S252
6. Bruun HH (1995) Hot-wire anemometry. Oxford University Press, Oxford
7. Chew YT, Khoo EC, Li GL (1998) An investigation of wall effects on hot-wire measurements using a bent sublayer probe. Meas Sci Technol 9:67-85
8. Chew YT, Khoo BC, Lim CP, Teo CJ (1998) Dynamic response of a hot-wire anemometer. Part II: a flush-mounted hot-wire and hot-film probes for wall shear stress measurements. Meas Sci Technol 9:764-778
9. Chew YT, Shi SX, Khoo BC (1995) On the numerical near-wall corrections of single hot-wire measurements. Int J Heat Fluid Flow 16:471-476
10. Cook WJ (1994) Response of hot-element wall shear stress gages in unsteady turbulent flows. AIAA J 32:1464-1471
11. Cook WJ, Giddings TA, Murphy JD (1988) Response of hot-element wall shear stress gages in laminar oscillating flows. ATAA 26:706-713
12. Khoo BC, Chew YT, Li GL (1997) Effects of imperfect spatial resolution on turbulence measurements in the very near-wall viscous sublayer region. Exp Fluids 22:327-335
13. Khoo BC, Chew YT, Lim CP, Teo CJ (1998) Dynamic response of a hot-wire anemometer. Part I: a marginally elevated hot-wire probe for near-wall velocity measurements. Meas Sci Technol 9:751-763
14. Khoo BC, Chew YT, Teo CJ, Lim CP (1999) The dynamic response of a hot-wire anemometer: III. voltage perturbation versus velocity perturbation testing for near-wall hot-wire/film probes. Meas Sci Technol 10:152-169
15. Kim J, Moin P, Moser R (1987) Turbulence statistics in fully developed channel flow at low Reynolds number. J Fluid Mech 177:133-166
16. Krishnamoorthy LV, Wood DH, Antonia RA, Chambers AJ (1985) Effect of wire diameter and overheat ratio near a conducting wall. Exp Fluids 3:121-127
17. Ligrani PM, Bradshaw P (1987) Spatial resolution and measurement of turbulence in the viscous sublayer using subminiature hot-wire probes. Exp Fluids 5:407-417
18. Ljus C, Johansson B, Almstedt A-E (2000) Frequency response correction of hot-film measurements in a turbulent airflow. Exp Fluids 29:36-41
19. Marusic I, Kunkel GJ, Porté-Agel F (2001) Experimental study of wall boundary conditions for large-eddy simulation. J Fluid Mech 446:309-320
20. Moen MJ, Schneider SP (1994) The effect of sensor size on the performance of flush-mounted hot-film sensors. J Fluids Eng 116:273-277
21. Rajagopalan S, Antonia RA (1979) Some properties of the large structure in a fully developed turbulent duct flow. Phys Fluids 22:614-622
22. Uddin AKM, Perry AE, Marusic I (1997) On the validity of Taylor's hypothesis in wall turbulence. J Mech Eng Res Dev 19/20:57-66