Material behaviour in metal cutting: Strains, strain rates and temperatures in chip formation

Journal of Materials Processing Technology

Volumn 121, Issue 1, 2002, Pages 123-135

  Jaspers, S P F C ^a   Dautzenberg, J H ^b  

^a Product and Process Development   (Netherlands)

^b EINDHOVEN UNIVERSITY OF TECHNOLOGY   (Netherlands)

Author keywords

Material behaviour; Metal cutting; Strain; Strain rate; Temperature

Indexed keywords

ALUMINUM ALLOYS; DEFORMATION; PLASTIC FLOW; STEEL; STRAIN RATE; THERMAL EFFECTS;

SHEAR PLANE TEMPERATURES;

METAL CUTTING;

EID: 0037074939     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0924-0136(01)01227-4     Document Type: Article

References (32)

1. On problems of plastic flow of materials
2. The development of constitutive relationships for material behaviour at high rates of strain
3. Material behaviour in conditions similar to metal cutting: Flow stress in the primary shear zone
4. New applications of CVD diamond
5. CVD-diamond coatings in sliding contact with Al, Al-17Si and steel
6. [1 0 0]-Textured diamond films for tribological applications
7. Unstable build-up formation when finish machining
8. Mechanism of formation of built-up edge
9. Recent developments in chip control research and applications
10. Chip formation, friction and high quality machined surfaces
11. The theory of plasticity applied to a problem of machining
12. Predicting the effects of very high cutting speeds on cutting forces, etc
13. Flow along tool-chip interface in orthogonal metal cutting
14. Frictional interactions between chip and rake face in continuous chip formation
15. Quantitative measurement of temperatures on diamond-coated tools during machining
16. Turning of metal matrix composites
17. 2 metal composite coatings deposited by closed field magnetron sputtering
18. An analysis of the mechanics of metal cutting
19. An experimental investigation of the influence of speed and scale on the strain-rate in a zone of intense plastic deformation
20. Temperature measurement in orthogonal metal cutting
21. The importance of allowing for the variation of thermal properties in the numerical computation of temperature distribution in machining
22. Calculation of temperature distributions in machining using a hybrid finite-element-boundary-element method
23. Development of a thermo-viscoplastic cutting model using finite element method
24. Finite element prediction of chip geometry and tool/workpiece temperature distributions in orthogonal metal cutting
25. Mechanics of machining