Effect of die approach geometry and bearing length on residual stress after bar drawing

Wire Journal International

Volumn 35, Issue 10, 2002, Pages 68-72

  Asakawa, Motoo ^a   Sasaki, Wataru ^a   Shishido, Shunsuke ^a  

^a WASEDA UNIVERSITY   (Japan)

Author keywords

[No Author keywords available]

Indexed keywords

DRAWING DIES; ELASTICITY; FINITE ELEMENT METHOD; FRICTION; PLASTICITY; RESIDUAL STRESSES; TENSILE STRESS;

AXIAL TENSILE RESIDUAL STRESS;

METAL DRAWING;

EID: 0036793698     PISSN: 02774275     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (7)

1. P. Renz, W. Steuff and R. Kopp, "Possibilities of influencing residual stresses in drawn wires and bars," Wire Journal International, January 1996, p. 64.
2. N. Kunntani and M. Asakawa, "Analysis of residual stress induced by bar and wire drawing," Journal of the Japan Society for Technology of Plasticity, Vol. 38, No. 433, 1997-2, p. 43.
3. S. Vijayakar, "Themal influences on residual stresses in drawn wire," Wire Journal International, June 1997, p. 117.
4. A. Nakagiri, K. Mathukawa, S. Watanabe and Y. Sasagawa, "Influence of die-wire contact length ratio on Chevron crack and optimum drawing condition in wire drawing," Journal of the Japan Society for the Technology of Plasticity Vol. 39, No. 447, 1998-4, p. 90.
5. A. Nakagiri, T. Yamano, M. Konaka, K. Yosida and M. Asakawa, "Chevron crack and optimum drawing condition in the diagram of mean stress and die-wire contact length ratio by FEM simulation," Wire Expo 2000 Conference Proceedings, The Wire Association International, Nashville, Tennessee, USA, June 2000, pp. 75-82.
6. A. Nakagiri, T. Yamano, M. Konaka, M. Asakawa, W. Sasaki and K. Yosida, "Behavior of residual stress and drawing stress in conical-type die and circle-type die drawing by FEM simulation and experiment," Wire Journal Internation, August 2001, pp. 72-80.
7. R.M. Shemenski, "Wiredrawing by computer simulation," Wire Journal International, April 1999, pp. 166-183.