On application of nonlinear k-ε models for internal combustion engine flows

Journal of Engineering for Gas Turbines and Power

Volumn 124, Issue 3, 2002, Pages 668-677

  Bianchi, G M ^a   Cantore, G ^b   Parmeggiani, P ^b   Michelassi, V ^c  

^a UNIVERSITY OF BOLOGNA   (Italy)

^b UNIVERSITY OF MODENA AND REGGIO EMILIA   (Italy)

^c ROMA TRE UNIVERSITY   (Italy)

Author keywords

[No Author keywords available]

Indexed keywords

ANISOTROPY; BARRELING; INTERNAL COMBUSTION ENGINES; NUMERICAL ANALYSIS; TURBULENCE; VISCOSITY;

REYNOLD STRESSES;

GAS TURBINES;

COMBUSTION; ENGINE; MATHEMATICAL ANALYSIS; MODELING; TURBULENT FLOW;

EID: 0036666996     PISSN: 07424795     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.1454115     Document Type: Article

References (41)

1. Arcoumanis, C., Whitelaw, J. H., Hentschel, W., and Schindler, K.-P., 1994, "Flow and Combustion in a Transparent 1.9 Liter Direct Injection Diesel Engine," Proc. Inst. Mech. Eng., Part D (J. Automob. Eng.). 208, pp. 191-205.
2. Bo, T., Clerides, D., Gosman, A. D., and Theodossopoulos, P., 1997, "Prediction of the Flow and Spray Processes in an Automobile DI Diesel Engine," SAE Paper 970882.
3. Burgess, D. E., and O'Rourke P. J., 1993, "Modelling Turbulence in Flows With a Strong Rotational Component," Los Alamos National Laboratory, Report No. LA-12552-MS.
4. Corcione, F. E., and Valentino, G., 1990, "Turbulence Length Scale Measurements by Two-Probe-Volume LDA Technique in a Diesel Engine," SAE Paper 902080.
5. El-Thary, S. H., and Haworth, D. C., 1992, "Directions in Turbulence Modeling for In-Cylinder Flows in Reciprocating Engines," J. Propul. Power, 8. No. 5, pp. 1040-1048.
6. Gosman, A. D., and Watkins, P., 1977, "A Computer Prediction Method for Turbulent Flow and Heat Transfer in Piston/Cylinder Assemblies," Proceedings of a Symposium on Turbulent Shear Flows, Pennsylvania State University, pp. 5.23-5.30.
7. Celik, I., and Yavuz, I., 1997, "An Assessment of Turbulence Scales Relevant to IC Engines," ASME Paper No. 97-ICE-5.
8. Arcoumanis, C., Whitelaw, J. H., Vafidis, C., and Hu, Z., 1990, "Tumbling Motion: A Mechanism for Turbulence Enhancement Spark Ignition Engines," SAE Paper 900060.
9. Han, Z., Reitz, R. D., Corcione, F. E., and Valentino, G., 1996, "Interpretation of k-ε Computed Turbulence Length-Scale Prediction for Engine Flows," Proceed. 26th. Symposium on Combustion, The Combustion Institute, Pittsburgh. PA, pp. 2717-2723.
10. Borgnakke, C., and Xiao, Y., 1991, "Compressible Turbulence Predicted by Reynolds Stress Models," SAE Paper 910260.
11. Burgess, D. E., and Amsden, A. A., 1993, "Modelling Turbulence in Flows With a Strong Rotational Component," Los Alamos National Laboratory, Report No. LA-12552-MS.
12. Tanner, F. X., and Reitz, R. D., 1999, "Scaling Aspects of the Characteristic Time Combustion Model in the Simulation of Diesel Engine," SAE Paper 1999-01-1175.
13. Morel, T., and Mansour, N. N., 1982, "Modeling of Turbulence in Internal Combustion Engines," SAE Paper 820040.
14. Amsden, A. A., O'Rourke, P. J., and Butler, T.D., 1989, "KIVA 2: A Computer Program for Chemically Reactive Flows With Sprays," Los Alamos National Labs, NTIS.
15. El-Tahry, S. H., 1983, "k-ε Equation for Compressible Reciprocating Flows," J. Energy, 7, No. 4.
16. Computational Dynamics Limited, 1998, "STAR-CD User Manual," CD-Computational Dynamics Limited/Analysis and Design, London.
17. Wilcox, D. C., and Rubesin, M.W., 1980, "Progress in Turbulence Modeling for Complex Flow Fields Including Effects of Compressibility," NASA Technical Paper 1517.
18. Bradshaw, P. B., Launder, E., and Lumley, J., 1991, "Collaborative Testing of Turbulence Models." ASME J. Fluids Eng., 113, pp. 3-4.
19. Leschziner, M. A., 1997, "Turbulence Modelling for Complex Flows-Necessary and Avoidable Compromises," Proceedings 7th Symposium on CFD, Beijing.
20. Ramos, J. I., 1989, Internal Combustion Engine Fundamentals, Hemisphere, Washington, DC.
21. Bray, K. N. C., et al., 1981, "Turbulence Production in Premixed Turbulent Films," Combust. Sci. Technol., 25, pp. 127-140.
22. Moriyoshi, Y., Kobayashi, H., and Kamomoto, T., 1989, "Experimental Evaluation of the Turbulence Model in Numerical Simulation of In-Cylinder Air Motion," JSAE Rev., 10, No. 2.
23. Coleman, G. N., and Mansour, N. N., 1991, "Modeling the Rapid Spherical Compression of Isotropic Turbulence," Phys. Fluids, 3, No. 9, pp. 2255-2259.
24. Hanjalic, K., and Launder, B. E., 1980, "Sensitizing the Dissipation Equation to Irrotational Strains," ASME J. Fluids Eng., 102, pp. 34-40.
25. Speziale, C. G., 1987, "On Non-Linear k-l and k-ε Models of Turbulence." J. Fluid Mech., 178, pp. 459-475.
26. Craft, T. J., Launder, B. E., and Suga, K., 1996. "Development and Application of a Cubic Eddy-Viscosity Model of Turbulence," Int. J. Heat Fluid Flow. 17, pp. 108-115.
27. Launder, B. E., and Spalding, D. B., 1972. Mathematical Models of Turbulence, Academic Press, San Diego, CA.
28. Leschziner, M. A., 1998, "Advances in Modeling Physically Complex Flows With Anisotropy-Resolving Closure and Related Validation," Proceedings of ASME Fluids Engineering Division Summer Meeting, Washington. DC. ASME, New York.
29. Rodi, W., 1987, "Turbulence Model for Practical Applications," von Karman Institute for Fluid Dynamics, Lecture Series 1987-06.
30. Reynolds, W. C., 1980, "Modeling of Fluid Motions in Engines: An Introductory Overview," Symposium on Combustion Modeling in Reciprocating Engines, Plenum Press, New York, pp. 131-155.
31. Durbin, P. A., and Speziale, C. G., 1991, "Local Anisotropy in Strained Turbulence at High Reynolds Numbers," ASME J. Fluids Eng., 113, pp. 707-709.
32. Pope, S. B., 1975, "A More General Effective-Viscosity Hypothesis," J. Fluid Mech., 72, Part 2, pp. 331-340.
33. Shi, T. H., and Zhu, J., 1995, "Calculations of Diffuser Flows With an Anisotropic k-ε model," NASA ICOMP-95-21.
34. Lien W., Chen, W. L., and Leschziner, M. A., 1996, Engineering Turbulence Modelling and Measurements-3, 91, Elsevier, New York.
35. Craft, T. J., Launder, B. E., and Suga, K., 1993. "Extending the Applicability of Eddy-Viscosity Model Through the Use of Deformation Invariant and Non-linear Elements," Proc. 5th Symposium Refined Flow Modelling and Turbulence Measurements, p. 125.
36. Apsley, A. D., and Leschziner, M. A., 1997, "A New Low-Re Non-linear Two-Equation Turbulence Model for Complex Flows," Proceedings 11th Symposium on Turbulent Shear Flows, Grenoble.
37. Gatski, T. B., and Speziale, C. G., 1993 "On Explicit Algebraic Stress Models for Complex Turbulent Flows," J. Fluid Mech., 254, pp. 59-78.
38. Sarkar, S., and Speziale, C. G., 1997, "Nonlinear and Anisotropic Turbulence Models," von Karman Institute for Fluid Dynamics, Lecture Series 1997-03.
39. Amsden, A. A., O'Rourke, P. J., and Butler, T. D., 1993, "Kiva- 3: A KIVA Program With Block-Structured Mesh for Complex Geometries," Los Alamos National Labs, Report No. LA-12503-MS.
40. Vafidis, C., 1986, "Aerodynamics of Reciprocating Engines," Ph.D. thesis, Imperial College of Science and Technology, Thermo-Fluids Section, London.
41. Bianchi, G. M., 1999, "Diesel-Spray Break-Up in Turbulent Flows," Ph.D. thesis. University of Bologna, - Polytechnic of Bari, Bari, Italy.