On determining the maximum emissions from electrically large sources

IEEE Transactions on Electromagnetic Compatibility

Volumn 44, Issue 1, 2002, Pages 79-86

  Wilson, Perry F ^a,b   Hill, David A ^a,b   Holloway, Christopher L ^a,b  

^a IEEE   (United States)

^b NATIONAL INSTITUTE OF STANDARDS AND TECHNOLOGY   (United States)

Author keywords

Directivity; Electrically large source; Emission testing; Quality factor; Reverberation chamber; Three loop method; Total radiated power

Indexed keywords

RADIATED POWER;

BANDWIDTH; COMPUTER SIMULATION; ELECTRIC FIELD MEASUREMENT; Q FACTOR MEASUREMENT; REVERBERATION; SIGNAL INTERFERENCE;

ELECTROMAGNETIC WAVE EMISSION;

EID: 0036464680     PISSN: 00189375     EISSN: None     Source Type: Journal    
DOI: 10.1109/15.990713     Document Type: Article

References (18)

1. Radiated emission measurements in completely absorber-lined anechoic chambers without ground planes
2. Emission characteristics of electrically small radiating sources from inside a TEM cell
3. On correlating TEM cell and OATS emission measurements
4. A three-loop method for determining the radiation characteristics of an electrically small source
5. An optically linked three-loop antenna system for determining the radiation characteristics of an electrically small source
6. An electromagnetic near-field sensor for simultaneous electric and magnetic-field measurements
7. Emission and immunity standards: Replacing field-at-a-distance measurements with total-radiated-power measurements
8. A model for the predicting the power delay profile characteristics inside a room
9. Electromagnetic theory of reverberation chambers
10. Reverberation chamber distributions 1: Maximum received power
11. Directivity of the test device in EMC measurements
12. Figure of merit for low-frequency anechoic chambers based on absorber reflection coefficients
13. A reflection coefficient derivation for the Q of a reverberation chamber