Adhesion of powders for inhalation: An evaluation of drug detachment from surfaces following deposition from aerosol streams

Pharmaceutical Research

Volumn 19, Issue 3, 2002, Pages 322-329

  Clarke, M J ^a   Peart, J ^b   Cagnani, S ^c   Byron, P R ^b  

^a VIRGINIA COMMONWEALTH UNIVERSITY   (United States)

^b UNIVERSITY OF COLORADO   (United States)

^c UNIVERSITY OF PARMA   (Italy)

Author keywords

Adhesion; Autohesion; Centrifugal particle detachment; Impaction; Inhalers; Powder aerosols

Indexed keywords

ACETAL DERIVATIVE; ALUMINUM; BECLOMETASONE DIPROPIONATE; SALBUTAMOL SULFATE;

ADHESION; AEROSOL; ARTICLE; CONTACT ANGLE; DRY POWDER; EVALUATION; HIGH PERFORMANCE LIQUID CHROMATOGRAPHY; PARTICLE SIZE; POWDER INHALER; PRIORITY JOURNAL; SCANNING ELECTRON MICROSCOPY; SURFACE PROPERTY; TECHNIQUE;

ADHESIVES; ADMINISTRATION, INHALATION; AEROSOLS; DRUG EVALUATION, PRECLINICAL; NEBULIZERS AND VAPORIZERS; POWDERS; SURFACE PROPERTIES;

EID: 0036195113     PISSN: 07248741     EISSN: None     Source Type: Journal    
DOI: 10.1023/A:1014451203619     Document Type: Article

References (27)

1. Adhesion of albuterol sulfate to plastics commonly found in dry powder inhalers (DPIs)
2. Impact force separation measurements - Their relevance in powder aerosol formulations
3. Experimental investigation of adhesion between powders and surfaces
4. The effect of particle size and concentration on the adhesive characteristics of a model drug-carrier interactive system
5. Fundamental considerations in the measurement of adhesional forces between particles using the centrifuge method
6. Influence of relative humidity on the adhesive properties of a model interactive system
7. Evaluation of the adhesion properties of salbutamol sulfate to inhaler materials
8. Measurement of the adhesive force of fine particles on tablet surfaces and method of their removal
9. Determination of interparticulate forces in ordered mixes
10. Interparticulate forces in binary and ternary ordered mixes
11. The role of component adhesion in the performance of dry powder inhalers
12. Small particle adhesion: Measurement and control
13. Variation in particle adhesion due to capillary and electrostatic forces
14. Size Distribution control of raw material for dry powder inhalers using the Aerosizer with the Aero-Disperser
15. Aerosol electrostatics. I: Properties of fine powders before and after aerosolization by dry powder inhalers
16. An assessment of an Andersen Mark-II Cascade Impactor
17. Variability in size distribution measurements using multiple Andersen Mark II Cascade Impactors
18. Size distribution measurements of metered dose inhalers using Andersen Mark II cascade impactors
19. Impaction and impingement techniques for powder inhalers-Comparisons, problems and validation
20. Calibration and mensuration issues for the standard and modified Andersen cascade impactor
21. Some future perspectives for unit dose inhalation aerosols
22. Turbohaler: A new powder inhaler for administration of drug to the airways
23. In-vitro evaluation of dry powder inhalers I: Drug deposition of commonly used devices
24. Dose emissions from marketed dry powder inhalers