Design for manufacturability of SISE parallel plate forced convection heat sinks

IEEE Transactions on Components and Packaging Technologies

Volumn 24, Issue 2, 2001, Pages 150-158

  Iyengar, Madhusudan ^b   Bar Cohen, Avram ^a,b  

^a IEEE   (United States)

^b University of Minnesota   (United States)

Author keywords

Bonding; Design for manufacturability; Folding; Forging; Least material; Machining; Modified die casting; Optimization; Skiving

Indexed keywords

LEAST MATERIAL OPTIMIZATION;

DIE CASTING; HEAT CONVECTION; MACHINING; OPTIMIZATION;

HEAT SINKS;

EID: 0035364699     PISSN: 15213331     EISSN: None     Source Type: Journal    
DOI: 10.1109/6144.926377     Document Type: Article

References (13)

1. Least-material optimization of vertical pin-fin, plate-fin, and triangular-fin heat sinks in natural convective heat transfer
2. Enhancing forced air convection heat transfer from an array of parallel plate fins using a heat pipe
3. Heat pipes: A practical and cost effective method for maximizing heat sink effectiveness
4. Heat sink optimization for maximum performance and minimum mass
5. Design for manufacturability of natural convection cooled heat sinks
6. Optimum arrays of longitudinal, rectangular fins in convective heat transfer
7. A flowstream based analytical model for design of parallel plate heat sinks
8. Cooling performance for plate fins for multichip modules
9. Development and implementation of a design for producibility method for precision planar products