A machining performance study in dry contour turning of aluminum alloys with flat-faced and grooved diamond tools

Machining Science and Technology

Volumn 5, Issue 2, 2001, Pages 269-289

  Balaji, A K ^a   Jawahir, I S ^b  

^a Department of Electrical and Computer Engineering   (United States)

^b UNIVERSITY OF KENTUCKY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CONTOUR MEASUREMENT; DIAMOND CUTTING TOOLS; FORCE MEASUREMENT; SURFACE ROUGHNESS; TURNING;

DRY CONTOUR TURNING;

ALUMINUM ALLOYS;

EID: 0035198095     PISSN: 10910344     EISSN: None     Source Type: Journal    
DOI: 10.1081/MST-100107847     Document Type: Article

References (18)

1. A mechanistic force model for contour turning
2. Towards predictive modeling and optimization of machining operations, keynote paper
3. Predicting the angle of chip flow for single-point cutting tools
4. On the behaviour of chip in steel cutting
5. The fundamental geometry of cutting tools
6. The chip-flow law and its consequences
7. Machining with double cutting edge tools: Symmetrical triangular cuts
8. General mechanics of cutting analyses for machining with plane faced cutting tools
9. Allowing for nose radius effects predicting the chip-flow direction and cutting forces in bar turning
10. Prediction of the chip flow direction and cutting forces in oblique machining with nose radius tools
11. Performance prediction models for turning with rounded corner plane faced lathe tools: Part 1 - Theoretical development
12. Performance prediction models for turning with rounded corner plane faced lathe tools: Part 2 - Verification of models
13. Predictive modeling of cutting forces and chip flow in machining with nose radius tools
14. On the controllability of chip breaking cycles and modes of chip breaking in metal machining
15. An investigation of three-dimensional chip flow in machining of steels with grooved chip forming tool inserts
16. Basic rules on the form of chip in metal cutting
17. The equivalent toolface (ET) approach for modeling chip curl in machining with grooved tools
18. Effects of cutting parameters on chip side-curl mechanisms and variable tool-chip contact in turning