Approach to on-machine motion error measurement of a linear slide

Measurement: Journal of the International Measurement Confederation

Volumn 29, Issue 1, 2001, Pages 51-62

  Fung, Eric H K ^a   Yang, S M ^a  

^a HONG KONG POLYTECHNIC UNIVERSITY   (Hong Kong)

Author keywords

[No Author keywords available]

Indexed keywords

ERROR ANALYSIS; ERROR COMPENSATION; SENSORS;

ACTIVE ERROR COMPENSATION (AEC); ON-MACHINE MEASUREMENT;

MEASUREMENT ERRORS;

EID: 0035148093     PISSN: 02632241     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0263-2241(00)00027-0     Document Type: Article

References (16)

1. Wu S.M. Dynamic data system: a new modeling approach. Trans. ASME, J. Eng. Ind. 99:1977;708-714.
2. Wu S.M., Ni J. New approaches to achieve better machine performance. Proc. USA-Japan Symp. Flexible Autom. 2:1988;1063-1068.
3. Fung E.H.K., Cheung S.M., Leung T.P. The implementation of an error forecasting and compensation system for roundness improvement in taper turning. Computers in Industry. 35:1998;109-120.
4. Whitehouse D.J. Some theoretical aspects of error separation techniques in surface metrology. J. Phys. E: Scient. Instrum. 9:1976;531-536.
5. Moore D. Design considerations in multiprobe roundness measurement. J. Phys. E: Scient. Instrum. 22:1989;339-343.
6. Gao W., Kiyono S., Nomura T. New multi-probe method of roundness measurements. Precision Eng. 19:(1):1996;37-45.
7. Gao W., Kiyono S. On-machine roundness measurement of cylindrical workpieces by the combined three-point method. Measurement. 21:(4):1997;147-156.
8. Zhang G.X. Four-point method of roundness and spindle error measurement. Ann. CIRP. 42:1993;593-596.
9. Zhang G.X., Zhang Y.H., Yang S.M., Li Z. A multipoint method for spindle error motion measurement. Ann. CIRP. 46:1997;441-445.
10. Tanaka H., Tozawa K., Sato H., O-hori M. Application of new straightness measurement method to large machine tool. Ann. CIRP. 30:1981;455-459.
11. Tozawa K., Sato H., O-hori M. A new method for the measurement of the straightness of machine tools and machined work. Trans. ASME, J. Mech. Des. 104:1982;587-592.
12. Tanaka H., Sato H. Extensive analysis and development of straightness measurement by sequential two-point method. Trans. ASME, J. Eng. Indus. 108:1986;176-182.
13. Kiyono S., Gao W. Profile measurement of machined surface with a new differential method. Precision Eng. 16:1994;212-218.
14. Li C.J., Li S., Yu J. High resolution error separation technique for in-situ straightness measurement of machine tools and workpiece. Mechatronics. 6:(3):1996;337-347.
15. Gao W., Kiyono S. High accuracy profile measurement of a machined surface by the combined method. Measurement. 19:(1):1996;55-64.
16. Gao W., Kiyono S. On-machine profile measurement of machined surface using the combined three-point method. JSME Int. J. Series C. 40:(2):1997;253-259.