The influence of inserting a Fuji pressure sensitive film between the tibiofemoral joint of knee prosthesis on actual contact characteristics

Clinical Biomechanics

Volumn 16, Issue 2, 2001, Pages 160-166

  Liau, Jiann Jong ^a   Hu, Chi Chung ^a   Cheng, Cheng Kung ^a   Huang, Chun Hsiung ^a,b   Lo, Wai Hee ^c  

^a NATIONAL YANG MING UNIVERSITY   (Taiwan)

^b MACKAY MEMORIAL HOSPITAL   (Taiwan)

^c TAIPEI VETERANS GENERAL HOSPITAL   (Taiwan)

Author keywords

Contact characteristics; Finite element model; Fuji pressure sensitive film; Knee prosthesis; Tibiofemoral joint

Indexed keywords

POLYURETHAN;

ARTICLE; CONTACT EXAMINATION; CONTROLLED STUDY; FEMUR; FILM; FINITE ELEMENT ANALYSIS; KNEE; KNEE PROSTHESIS; MATERIALS; MEASUREMENT; MODEL; PRESSURE; PRESSURE SENSE; PRIORITY JOURNAL; TIBIA;

BIOMECHANICS; FINITE ELEMENT ANALYSIS; HUMANS; KNEE JOINT; KNEE PROSTHESIS;

EID: 0035124771     PISSN: 02680033     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0268-0033(00)00040-1     Document Type: Article

References (25)

1. Tibiofemoral contact pressures in degenerative joint disease
2. The effect of conformity, thickness and material on stresses in ultra-high molecular weight component for total joint replacement
3. Analysis of the failure of 122 polyethylene inserts from uncemented tibial knee components
4. The influence of contact stress on the wear of UHMWPE for total replacement hip prosthesis
5. Non-uniformity of contact stress on polyethylene inserts in total knee arthroplasty
6. The influence of contact alignment of the tibiofemoral joint of the prostheses in in-vitro biomechanical testing
7. Reversible cartilage staining technique for defining articular weight-bearing surfaces
8. Load-bearing mode of the knee joint, physical behavior of the knee joint with or without menisci
9. An improved method for measuring tibiofemoral contact areas in total knee arthroplasty: a comparison of K-scan sensor and Fuji film
10. Determining the in vitro areas of contact in the canine shoulder
11. A stereophotogrammetric method for determining in situ contact areas in diarthrodial joints and a comparison with other methods
12. Quantitation of pressure sensitive film using digital image scanning
13. Contact area and pressure distributions in the subtalar joint
14. Contact pressure predictions in total knee replacements Part 1: general elasticity solution for elliptical layered contacts
15. Contact pressure prediction in total knee replacements. Part 2: application to the design of total knee joint replacements
16. Stresses in polyethylene components of contemporary total knee replacement
17. The conflicting requirements of laxity and conformity in total knee replacement
18. Contact stress gradient detection limits of pressensor film
19. Experimental and theoretical study of the contact mechanics of five total knee joint replacements
20. The yielding, plastic flow, and fracture behavior of ultra-high molecular weight polyethylene used in total joint replacements
21. Effects of inserting a pressensor film into articular joints on the actual contact mechanics
22. Residual stresses in ultra-high molecular weight polyethylene loaded cyclically by a rigid moving indenter in nonconforming geometries