Tribological layers and the wear of ductile materials

Wear

Volumn 245, Issue 1-2, 2000, Pages 204-215

  Kapoor, A ^a   Franklin, F J ^a  

^a UNIVERSITY OF SHEFFIELD   (United Kingdom)

Author keywords

Fracture; Mechanical wear; Tribological layer

Indexed keywords

DELAMINATION; DUCTILITY; FAILURE ANALYSIS; HARDNESS; PLASTIC DEFORMATION; SURFACE ROUGHNESS; TRIBOLOGY;

TRIBOLOGICAL LAYERS; WEAR DEBRIS;

WEAR OF MATERIALS;

DUCTILE MATERIAL; TRIBOLOGY; WEAR;

EID: 0034305924     PISSN: 00431648     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0043-1648(00)00480-4     Document Type: Conference Paper

References (44)

1. A lamination wear mechanism based on plastic waves
2. Wear mechanisms
3. Plastic ratchetting as a mechanism of metallic wear
4. Wear through the plastic interaction of cylindrical asperities in sliding
5. A model for the mild ratchetting wear of metals
6. An overview of the delamination theory of wear
7. Mode II stress intensities for a crack parallel to the surface of an elastic half-space subjected to a moving point load
8. The influence of crack face friction and trapped fluid on surface initiated rolling contact fatigue cracks
9. Sub-surface cracks under conditions of slip stick and separation caused by a moving compressive load
10. A pitting model for rolling contact fatigue
11. Three-dimensional fracture mechanics analysis of pit formation mechanism under lubricated rolling-sliding contact loading
12. A continuous observation on rolling-sliding contact fatigue crack initiation and propagation - effect of viscosity and contamination of lubricant
13. Prediction of Archard's wear coefficient assuming a low cycle fatigue mechanism
14. The calculation of wear coefficients for plastic contacts
15. A re-evaluation of the life to rupture of ductile metals by cyclic plastic strain
16. Mechanical properties of materials under hydrostatic pressure
17. Wear by ratchetting
18. The steady state wear behaviour of pearlitic rail steel under dry rolling-sliding contact conditions
19. The effect of rolling direction reversal on the wear rate and wear mechanism of pearlitic rail steel
20. The role of rupture in wear of materials
21. Comments on the sliding wear of metals
22. Microstructural evolution during sliding
23. Precipitate coarsening rates induced by frictional heating and deformation
24. An analysis of plastic deformation in rolling contact
25. Cumulative plastic flow in rolling and sliding line contact
26. An elastic-plastic finite element model of rolling contact. Part I. Single contacts, Part II. Repeat contacts
27. A direct analysis of two-dimensional elastic-plastic rolling contact
28. Application of the direct method for a nonlinear-kinematic-hardening material under rolling/sliding line contact: Constant ratchetting rate
29. Plastic flow of rollers loaded above their yield point
30. A theoretical and experimental investigation of material ratchetting in a Bree beam element
31. Experimental investigation into the influence of cyclic phenomena of metals on structural ratchetting behaviour
32. Cyclic hardening properties of hard drawn copper and rail steels
33. The influence of strain hardening on cumulative plastic deformation in rolling and sliding line contact
34. Stress state dependence of cyclic ratchetting behaviour of two rail steels
35. A mathematical representation of the multiaxial Bauschinger Effect
36. Transformation of a non-linear kinematic hardening rule, to a multisurface form under isothermal and nonisothermal conditions
37. Deterioration of rolling contact fatigue life of pearlitic rail steel due to dry-wet rolling-sliding line contact
38. Contact of nominally flat surfaces
39. Fractal model of elastic-plastic contact between rough surfaces