Measurement of eddy diffusivity of momentum in film cooling flows with streamwise injection

Journal of Turbomachinery

Volumn 122, Issue 1, 2000, Pages 178-183

  Kaszeta, R W ^a   Simon, T W ^a  

^a UNIVERSITY OF MINNESOTA   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CALCULATED VALUES; DENSITY RATIO; EDDY DIFFUSIVITIES; FILM COOLING; FREESTREAM TURBULENCE; INJECTION ANGLES; INJECTION HOLES; LENGTH SCALE; MEAN VELOCITIES; MOMENTUM FLUX RATIOS; TURBULENT SHEAR STRESS; TURBULENT TRANSPORTS; VELOCITY COMPONENTS; WALL-NORMAL DIRECTION;

COOLANTS; COOLING;

DIFFUSION;

COOLING; FILM; FLOW; GAS TURBINE;

EID: 0034025420     PISSN: 0889504X     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.555421     Document Type: Article

References (17)

1. Bergeles, G., Gosman, A. D., and Launder, B. E., 1978, "The Turbulent Jet in a Cross Stream at Low Injection Rates: A Three-Dimensional Numerical Treatment," Numerical Heat Transfer, Vol. 1, pp 217-242.
2. Burd, S. W., Kaszeta, R. W., and Simon, T. W., 1998, "Measurements in Film Cooling Flows: Hole L/D and Turbulence Intensity Effects," ASME JOURNAL OF TURBOMACHINERY, Vol. 120, pp. 791-798.
3. Burd, S. W., and Simon, T. W., 1999, "Turbulence Spectra and Length Scales Measured in Film Coolant Flows Emerging From Discrete Holes," ASME JOURNAL OF TURBOMACHINERY, Vol. 121, pp. 551-557.
4. Eckert, E. R. G., 1987, "Cross Transport of Energy in Fluid Streams," Wärme Stoff, vol. 21, pp. 73-81.
5. Forth, C. J. P., and Jones, T. V., 1986, "Scaling Parameters in Film Cooling," Proc. 8th Intl. Heat Transfer Conference, Vol. 3, pp. 1271-1276
6. Goebel, S. G., Abuaf, N., Lovett, J. A., and Lee, C.-P., 1993, "Measurements of Combustor Velocity and Turbulence Profiles," ASME Paper No. 93-GT-228.
7. Kaszeta, R. W., Simon, T. W., Oke, R. A., and Burd, S. W., 1998, "Flow Measurements in Film Cooling Flows With Lateral Injection," ASME Paper No. 98-GT-54.
8. Kohli, A., and Bogard, D. G., 1997, "Adiabatic Effectiveness, Thermal Fields, and Velocity Fields for Film Cooling With Large Angle Injection," ASME JOURNAL OF TURBOMACHINERY, Vol. 119, pp. 352-358.
9. Laufer, J., 1953, "The Structure of Turbulence in Fully-Developed Pipe Flows," NACA Report 1174.
10. Leylek, J. H., and Zerkle, R. D., 1994, "Discrete-Jet Film Cooling: A Comparison of Computational Results With Experiments," ASME JOURNAL OF TURBOMACHINERY, Vol. 116, pp. 358-368.
11. McMahon, H. M., Hester, D. D., and Palfery, J. G., 1971, "Vortex Shedding from a Turbulent Jet in a Cross-Wind," Journal of Fluid Mechanics, Vol. 48, No. 1, pp. 73-80.
12. Quarmby, A., and Quirk, R., 1974, "Axisymmetric and Non-Axisymmetric Turbulent Diffusion in a Plain Circular Tube at High Schmidt Number," Intl. Journal Heat Mass Transfer, Vol. 17, pp. 143-174
13. Russ, S., and Simon, T. W., 1990, "Signal Processing Using the Orthogonal Triple-Wire Equations," Flow Lines, the TSI quarterly magazine, Winter.
14. Sathyamurthy, P., and Patankar, S. V., 1992, "Film Cooling Studies Using a Three-Dimensional Parabolic Procedure," University of Minnesota Supercomputer Institute Research Report 92/44.
15. Starr, V. P., 1968, Physics of Negative Viscosity Phenomena, McGraw-Hill.
16. Wang, L., Tsang, H., Simon, T. W., and Eckert, E. R. G., 1996, "Measurements of a Mean Flow and Eddy Transport Over a Film Cooling Surface," in: Proc. 31st National Heat Transfer Conference, Vol. 5, ASME HTD-Vol. 327, pp. 71-79.
17. Xu, J. Z., Ko, S. Y., Chen, S. J., and Tsou, F. K., 1990, "Computer Simulation of Film-Cooling With Coolants From One and Two Rows of Holes," ASME Paper No. 90-WA/HT-7.