메뉴 건너뛰기




Volumn 19, Issue 9, 2000, Pages 1619-1621

Novel trityl activators with new weakly coordinating anions derived from C6F41,2-[B(C6F5)2] 2: Synthesis, strussctures, and olefin polymerization behavior

Author keywords

[No Author keywords available]

Indexed keywords

CHEMICAL ACTIVATION; FLUORINE COMPOUNDS; NEGATIVE IONS; OLEFINS; POLYMERIZATION; SALTS; STOICHIOMETRY;

EID: 0033752162     PISSN: 02767333     EISSN: None     Source Type: Journal    
DOI: 10.1021/om0001974     Document Type: Article
Times cited : (118)

References (37)
  • 8
    • 0033444396 scopus 로고    scopus 로고
    • and references therein
    • (d) Luo, L.; Marks, T. J. Top. Catal. 1999, 7, 97 and references therein.
    • (1999) Top. Catal. , vol.7 , pp. 97
    • Luo, L.1    Marks, T.J.2
  • 16
    • 33645650406 scopus 로고
    • U.S. Patent 5,447,895, (Northwestern University)
    • (b) Marks, T. J.; Jia, L.; Yang, X. U.S. Patent 5,447,895, 1995 (Northwestern University).
    • (1995)
    • Marks, T.J.1    Jia, L.2    Yang, X.3
  • 19
    • 33645648715 scopus 로고    scopus 로고
    • note
    • -1, final R indices R1 = 0.0446 and wR2 = 0.1158, GOF = 1.061, 15 restraints, 733 parameters. The restraints were applied to geometry and anisotropic displacement parameters of atoms in disordered solvent molecules, to aid their refinement. There were no restraints on the cations and anions.
  • 30
    • 85085718980 scopus 로고    scopus 로고
    • 14d
    • 14d
  • 33
    • 85085719526 scopus 로고    scopus 로고
    • note
    • 20d substituents are known, but those with less bulky groups tend to form dimers and undergo other side reactions,
  • 37
    • 33645640636 scopus 로고    scopus 로고
    • note
    • 2 in toluene (20 mL each) were sequentially introduced in the same manner so as to give a final concentration of 2 μM for each. Ethylene uptake was monitored using a calibrated mass flow meter; constant monomer flow was observed typically within 5 min after catalyst introduction. The temperature was controlled (to ca. ± 2 °C) using an external cooling jacket connected to a recirculating heating/cooling bath and was monitored by an RTD sensor placed in a thermocouple well in contact with the reactor contents. Polymerizations were conducted for a time period corresponding to 20-30 min, following attainment of steady-state conditions (i.e., constant T and ethylene flow) in the reactor, and polymerizations were quenched by the addition of MeOH through an overpressurized sample vessel. Polymer samples were isolated by filtration, washed with MeOH, and dried in vacuo at 80 °C for 24 h prior to weighing.


* 이 정보는 Elsevier사의 SCOPUS DB에서 KISTI가 분석하여 추출한 것입니다.