Flow visualization of the gas-assisted injection molding process

Advances in Polymer Technology

Volumn 16, Issue 3, 1997, Pages 175-183

  Yang, S Y ^a   Liou, S J ^a   Liou, W N ^a  

^a NATIONAL TAIWAN UNIVERSITY   (Taiwan)

Author keywords

[No Author keywords available]

Indexed keywords

FLOW VISUALIZATION; PLASTIC PARTS;

MOLD FILLING PHENOMENA;

INJECTION MOLDING;

EID: 0031236560     PISSN: 07306679     EISSN: None     Source Type: Journal    
DOI: 10.1002/(SICI)1098-2329(199723)16:3<175::AID-ADV2>3.0.CO;2-Q     Document Type: Article

References (20)

1. G. I. Beall, Kuntstoff, 82, 9 (1992).
2. I. R. Baxi, SPE ANTEC Papers, 2268 (1991).
3. S. Shah, SPE ANTEC Papers, 1494 (1991).
4. H. Eckhardt, Eng. Plast., 4, 367 (1991).
5. A. Lanvers and W. Michaeli, SPE ANTEC Papers, 1796 (1992).
6. L. S. Turng and V. W. Wang, SPE Tech. Papers, 297 (1991).
7. L. S. Turng, SPE Tech. Papers, 74 (1993).
8. L. S. Turng, Adv. Polym. Techn., 14, 1 (1995).
9. G. Sherbelis, SPE Tech. Papers, 411 (1994).
10. R. E. Khayat, A. Derdouri and L. P. Hebert, J. Non-Newtonian Fluid Mech., 57, 253 (1995).
11. S. C. Chen, K. F. Hsu and K. S. Hsu, Num. Heat Transfer, 28, 121 (1995).
12. H. Potente and M. Hansen, Int. Polym. Proc., 8, 4 (1993).
13. A. J. Poslinski and V. K. Stokes, Polym. Eng. Sci., 35, 877 (1995).
14. S. C. Chen, N. T. Cheng, and K. S. Hsu, Int. Commun. Heat Mass Transfer, 22, 319 (1995).
15. S. Y. Yang and S. J. Liou, Adv. Polym. Techn., 14, 197 (1995).
16. S. Y. Yang, F. Z. Huang and W. N. Liou, Polym. Eng. Sci., 36, 2824 (1996).
17. A. Lanves, Doctoral dissertation, IKV, Aachen, Germany (1993).
18. T. Zheng, J. Koskey, and T. Altan, SME Tech. Papers, CM93-416 (1993).
19. K. Yamamoto, K. Harada, and Y. Okada, PPS Regional Meeting, 218 (1994).
20. S. Y. Yang and F. Z. Huang, Int. Polym. Proc. 10, 186 (1995).