A study of rib geometry for gas-assisted injection molding

Polymer Engineering and Science

Volumn 36, Issue 23, 1996, Pages 2824-2831

  Yang, S Y ^a   Huang, F Z ^a   Liau, W N ^a  

^a NATIONAL TAIWAN UNIVERSITY   (Taiwan)

Author keywords

[No Author keywords available]

Indexed keywords

GASES; HARDNESS; MOLDS; PLATES (STRUCTURAL COMPONENTS);

FILLET GEOMETRY; GAS CHANNELS; GAS-ASSISTED INJECTION MOLDING; LARGE PLATE PARTS; RIB GEOMETRY; RIGIDITY; STRUCTURAL RIBS;

INJECTION MOLDING;

EID: 0030407474     PISSN: 00323888     EISSN: None     Source Type: Journal    
DOI: 10.1002/pen.10683     Document Type: Article

References (17)

1. W. J. Fallows, Plast. Eng., December 1982, p. 27.
2. F. Z. Huang, Master's thesis, National Taiwan University (1994).
3. R. Bernhardt, Eng. Plastics, 5, 397 (1992).
4. G. Menges, Int. Polym. Sci. Technol., 18, 40 (1991).
5. K. C. Rusch, SPE ANTEC Tech. Papers, 35, 1014 (1989).
6. S. Shah and D. Hlavaty, SPE ANTEC Tech. Papers, 37, 1479 (1991).
7. H. Potente and M. Hensen, Int. Polym. Proc., 8, 345 (1993).
8. A. J. Poslinski, P. R. Oehler, and V. K. Stokes, Polym. Eng. Sci., 35, 877 (1995).
9. L. S. Turng, Adv. Polym. Technol., 14, 1 (1995).
10. S. C. Chen, N. T. Cheng, and K. S. Hsu, Int. Com. in Heat and Mass Tranf., 22, 319 (1995).
11. R. Khayat, A. Derdouri, and A. Hebert, J. Non-Newtonian Fluid Mech., 57, 253 (1995).
12. T. Zheng, J. Koskey, and T. Altan, SME Tech. Papers CM93-416 (1993).
13. H. Findeisen, PhD Dissertation, IKV, Aachen, Germany (1994).
14. I. Baxi, SPI Annual Conf., Structural Div., 18, 158 (1990).
15. S. Y. Yang and S. J. Liou. Adv. in Polym. Technol., 14, 197 (1995).
16. S. Middleman, Fundamentals of Polymer Processing, McGraw-Hill, Inc., New York (1977).
17. S. C. Chen, K. F. Hsu, and K. S. Hsu, Numerical Heat Transfer, 28, 121 (1995).