Quantitative Analysis of Combined Impingement and Through Air Drying of Paper

Canadian Journal of Chemical Engineering

Volumn 75, Issue 1, 1997, Pages 176-189

  Chen, G ^a,b   Crotogino, R H ^a   Douglas, W J M ^a  

^a MCGILL UNIVERSITY   (Canada)

^b HONG KONG UNIVERSITY OF SCIENCE AND TECHNOLOGY   (Hong Kong)

Author keywords

Air drying; Combined impingement and through drying; Impingement; Paper; Through flow

Indexed keywords

DRYING; MATHEMATICAL MODELS; MOISTURE;

AIR DRYING; COMBINED IMPINGEMENT AND THROUGH AIR DRYING PROCESS; WATER REMOVAL RATE;

PAPERMAKING;

EID: 0031070117     PISSN: 00084034     EISSN: None     Source Type: Journal    
DOI: 10.1002/cjce.5450750126     Document Type: Article

References (18)

1. Chen, G., "Impingement and Through Air Drying of Paper", Ph.D. Thesis, Chem. Eng. Dept, McGill University, Montreal (1994).
2. Chen, G. and W. J. M. Douglas, "Through Drying of Paper", Drying Technol. 15 (in press, 1997).
3. Chen, G., V. G. Gomes, and W. J. M. Douglas, "Impingement Drying of Paper", Drying Technol. 13, 1331-1344 (1995).
4. Chen, G., R. H. Crotogino and W. J. M. Douglas, "Fundamental Characteristics of Combined Impingement and Through Air Drying of Paper", Can. J. Chem. Eng. 75, 000-000 (1997).
5. Crotogino, R. H. and V. Allenger, "Mathematical Model of the Papridryer Process", Trans. Technical Section, CPPA 5, 84-91 (1979).
6. Hashemi, S. J., R. H. Crotogino and W. J. M. Douglas, "A Novel Technique for Measurement of Transient Moisture Content Profiles and Moisture Diffusion in Paper", Presented at 45th Canadian Chem. Eng. Conf., Quebec, QC, October 15-18 (1995).
7. Lee P. F. and J. A. Hinds, "Optimizing Dryer Performance: Modeling Heat and Mass Transfer within a Moist Sheet of Paper or Board", TAPPI 64, 39-44 (1981).
8. Martin, H., "Heat and Mass Transfer Between Impinging Gas Jets and Solid Surface", in "Adv. Heat Trans." Vol. 13, T. F. Irvine and J. P. Harlnett, Eds., Academic Press, Orlando, FL (1977), pp. 1-60.
9. Mickley, H., R. C. Ross, A. L. Squyers and W. E. Stewart, "Heat, Mass and Momentum Transfer for Flow Over A Flat Plate with Blowing and Suction", N ACA TN-3208, National Advisory Committee for Aeronautics, U.S.A. (1954).
10. Navarri, P., A. Genvaudan and J. Andrieu, "Preliminary Study of Drying of Coated Film Heated by Infrared Radiation", in "Drying '92", A.S. Mujumdar, Ed., Elsevier, Amsterdam (1992), pp. 722-728.
11. Polat, O., R. H. Crotogino and W. J. M. Douglas, 'Transport Phenomena Analysis of Through Drying Paper", Ind. Eng. Chem. Res. 31, 736-743 (1992).
12. Polat, S., and W. J. M. Douglas, "Heat Transfer under Multiple Slot Jets Impinging on a Permeable Moving Surface", AIChE J. 36, 1370-1378 (1990).
13. Polat, S., A. S. Mujumdar and W. J. M. Douglas, "Impingement Heat Transfer under a Confined Slot Jet, I. Effect of Surface Throughflow", Can. J. Chem. Eng. 69, 266-273 (1991a).
14. Polat, S., A. S. Mujumdar, and W. J. M. Douglas, "Impingement Heat Transfer under a Confined Slot Jet, II. Effect of Surface Motion and Throughflow", Can. J. Chem. Eng. 69, 274-280 (1991b).
15. Polat, S., "Heat and Mass Transfer in Impingement Drying", Drying Technol. 11, 1147-1176 (1993).
16. Randall, K. R., "Using High Velocity Impingement Air to Improve Through Drying Performance on Semi-permeable Webs", in "Drying '84", A.S. Mujumdar, Ed., Hemisphere, New York (1984), pp. 254-263.
17. Saad, N. R., S. Polat and W. J. M. Douglas, "Confined Multiple Impinging Slot Jets without Cross flow Effects", Int. J. Heat and Fluid Flow 13, 2-14 (1992).
18. van Heiningen, A. R. P., "Heat Flux at the Impingement Surface with Through Flow", personal communication (1993).