Reaction rate spectroscopy for a catalyzed reaction of gases

Bulletin of the Chemical Society of Japan

Volumn 77, Issue 11, 2004, Pages 1973-1986

  Yasuda, Yusuke ^a   Matsumoto, Akira ^a   Oda, Ryo ^a  

^a UNIVERSITY OF TOYAMA   (Japan)

Author keywords

[No Author keywords available]

Indexed keywords

CATALYSIS; FREQUENCY RESPONSE; PARTIAL PRESSURE; REACTION KINETICS; SPECTROSCOPY; THERMODYNAMICS;

ENERGY DROP; REACTION RATE;

GASES;

ALUMINUM DERIVATIVE; ALUMINUM OXIDE; CARBON DIOXIDE; CARBON MONOXIDE; COPPER; PLATINUM; RUBIDIUM;

ARTICLE; CATALYSIS; ENERGY METABOLISM; FREQUENCY ANALYSIS; GAS ANALYSIS; PRESSURE MEASUREMENT; REACTION ANALYSIS; REACTION RATE SPECTROSCOPY; SPECTROSCOPY; THERMODYNAMICS; VALIDATION PROCESS;

EID: 9944265749     PISSN: 00092673     EISSN: None     Source Type: Journal    
DOI: 10.1246/bcsj.77.1973     Document Type: Article

References (44)

1. M. M. Slin'ko and N. I. Jaeger, "Oscillating Heterogeneous Catalytic Systems," Studies in Surface Science and Catalysis, Vol. 86, Elsevier, Amsterdam (1994).
2. R. Imbihl and G. Ertl, Chem. Rev., 95, 697 (1995).
3. D. Kondepudi and I. Prigogine, "Modern Thermodynamics," Wiley, Chichester (1998).
4. S. W. Weller, Catal Rev.-Sci. Eng., 34, 227 (1992).
5. C. O. Bennett, Adv. Catal., 44, 329 (1999).
6. M. Pekar and J. Koubek, Appl. Catal., A, 177, 69 (1999).
7. Y. Yasuda, J. Phys. Chem., 93, 7185 (1989).
8. J. R. Schrieffer and J. H. Sinfelt, J. Phys. Chem., 94, 1047 (1990).
9. Contrary to the expectation, the amplitude became higher in a reaction system at a steady state as shown below.
10. Y. Yasuda, Heterog. Chem. Rev., 1, 103 (1994).
11. S. C. Reyes and E. Iglesia, "Catalysis," Royal Society of Chemistry (1994), Vol. 11, Chap. 2.
12. Y. Yasuda, K. Iwai, and K. Takakura, J. Phys. Chem., 99, 17852 (1995).
13. Y. Yasuda and Y. Kuno, J. Phys. Chem. A, 102, 4878 (1998).
14. Y. Yasuda and Y. Kuno, J. Phys. Chem. B, 103, 3916 (1999).
15. Y. Yasuda, H. Mizusawa, and T. Kamimura, J. Phys. Chem. B, 106, 6706 (2002).
16. T. Engel and G. Ertl, Adv. Catal, 28, 1 (1976).
17. X-species were not distinguished in a previous paper.15 The two-step model was modified to the three-step model in this work, because the two-step model was not effective to reproduce every result obtained by the three kinds of catalysts adopted.
18. Z ≒ 0 was derived.
19. s.
20. (s) < 0.
21. n ≦ 1), the value of δτ becomes 1/5.
22. X appears.
23. Y.
24. 1) > 0 (A3) which also is not acceptable.
25. AX on every catalyst were determined semi-empirically. Because they were very close to -1/3 in repeated numerical simulations, they were assumed to be -1/3.
26. BY = -1 on every catalyst were determined semi-empirically. Because they were very close to -1 in repeated numerical simulations, they were assumed to be -1.
27. BY* should be independent of it.
28. AX. The simple result is necessarily independent of ω and constant.
29. T. Engel and G. Ertl, "The Chemical Physics of Solid Surfaces and Heterogeneous Catalysis," D. A. Eng, D. P. Woodruff, Elsevier, Amsterdam (1982), Vol. 4, Chap. 3.
30. It is found that surface species may migrate not only from weakly bound sites to strongly bound sites (enthalpy favorable process) but also from strongly bound sites to weakly bound sites (enthalpy unfavorable process) during heterogeneous catalysis reactions [W. X. Huang, X. H. Bao, H. H. Rotermund, and G. Ertl, J. Phys. Chem. B, 106, 5645 (2002)].
31. G. C. Bond, "Catalysis by Metals," Academic Press, London (1962).
32. G. C. Bond and M. A. Keane, Catal. Rev.-Sci. Eng., 42, 323 (2000).
33. An adsorbate induced surface reconstruction is proposed as a possible driving force for oxide formation on Pt(100) during CO oxidation [J. Dicke, H. H. Rotermund, and J. Lauterbach, Surf. Sci., 454-456, 352 (2000)].
34. 2 production rate on Pt(110) [B. L. M. Hendriksen and J. W. M. Frenken, Phys. Rev. Lett., 89, 046101 (2002)].
35. 2 production rate on Pt(110) [B. L. M. Hendriksen and J. W. M. Frenken, Phys. Rev. Lett., 89, 046101 (2002)].
36. T) was ca. 40 kJ/mol on Pt and consistent with the excess energy observed.
37. T) was ca. 40 kJ/mol on Pt and consistent with the excess energy observed.
38. T) was ca. 40 kJ/mol on Pt and consistent with the excess energy observed.
39. A. Oertzen, H. H. Rotermund, A. S. Mikhailov, and G. Ertl, J. Phys. Chem. B, 104, 3155 (2000).
40. H. Eyring, J. Chem. Phys., 3, 107 (1935).
41. M. G. Evans and M. Polanyi, Trans. Faraday Soc., 31, 875 (1935).
42. J. Horiuti, J. Res. Inst. Catal., Hokkaido Univ., 5, 1 (1957).
43. sys. [G. M. Barrow, "Physical Chemistry, 6th ed," McGraw, Boston (1996)].
44. A dynamic method for characterization of adsorptive properties of solid catalysts was named "adsorption-rate spectrum" [L. Polinski and L. Naphtali, Adv. Catal., 19, 241 (1969)]. Relaxation techniques such as acoustic wave and alternating electric field was suggested by Eigen to be named "relaxation spectroscopy".4 The present method based on δJ may be named "reaction-rate spectroscopy", because the novel method would play an important role in modern thermodynamics.