A CONSTANT ENGAGEMENT OFFSET FOR 2-1/2 D TOOL PATH GENERATION

ASME International Mechanical Engineering Congress and Exposition, Proceedings (IMECE)

Volumn 1998-R, Issue , 1998, Pages 475-481

  Stori, James A ^a   Wright, Paul K ^a  

^a UNIVERSITY OF CALIFORNIA   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CHIP GEOMETRY; CONVEX GEOMETRY; CUTTER ENGAGEMENT; FORCE VARIATION; MACHINING STRATEGY; MATERIAL REMOVAL; TOOLPATH GENERATIONS; TOOLPATHS; WHILE CORNERING;

GAS TURBINES;

EID: 85124357699     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/IMECE1998-1061     Document Type: Conference Paper

References (11)

1. Dragomatz, D., and Mann, S., 1997, "A classified bibliography of literature on NC milling path generation," Computer-Aided Design, Vol. 29, No. 3, pp. 239-247.
2. Gray, A., 1993, Modern differential geometry of curves and surfaces, CRC Press.
3. Iwabe, H., Fujii, Y., Saito, K., and Kisinami, T., 1989, "Study on Corner Cut by End Mill - Analysis of Cutting Mechanism and New Cutting Method at Inside Corner," / ofJSPE, Vol. 55, No. 5, pp. 841-846 (in Japanese)
4. Kramer, T.R., 1992, "Pocket Milling with Tool Engagement Detection," Journal of Manufacturing Systems, Vol. 11, No. 2, pp. 114-123.
5. Smith, S., Cheng, E., and Zamudio, C, 1991, "Computer-Aided Generation of Optimum Chatter-Free Pockets," J. of Materials Processing Technology, Vfel. 28, pp.275-283.
6. Spence, A., and Altintas, Y., 1991, " C A D Assisted Adaptive Control for Milling," / of Dynamic Systems, Measurement, and Control, Vol. 113, pp. 445-450.
7. Spence, A. and Altintas, Y, 1994, "A Solid Modeller Based Millling Process Simulation and Planning System," Journal of Engineering for Industry, Vol. 116, pp. 61-69.
8. Stoker, J.J., 1969, Differential Geometry, Wiley-Interscience, New York, pp. 31-34.
9. Tlusty, J., Smith, S., and Zamudio, C, 1990, "New NC Routines for Quality in Milling," Annals ofthe CIRP, Vol 39. No. 1, pp. 517-521.
10. Tsai, M.D., Takata, S., Inui, M ., Kimura, F. and Sata, T., 1991, "Operadon Planning Based on Cutting Process Models," Annals of the CIRP Vol. 40, No. l,pp.95-98.
11. Wang, F-C. and Yang, D.C.H, 1993, "Nearly Arc-Length Parametrized Quintic Spline Interpolation for Precision Machining", Computer-Aided Design, Vol. 25, No.5, pp. 281-288.