Unsteady convection model for heat release analysis of IC engine pressure data

SAE Technical Papers

Volumn , Issue , 2000, Pages

  Catania, A E ^a   Misul, D ^a   Mittica, A ^a   Spessa, E ^a  

^a POLITECNICO DI TORINO   (Italy)

Author keywords

[No Author keywords available]

Indexed keywords

COMBUSTION CHAMBERS; CURVE FITTING; DIESEL ENGINES; HEAT FLUX; INTEGRATED CIRCUITS; POLYNOMIAL APPROXIMATION; THERMODYNAMIC PROPERTIES; TIMING CIRCUITS;

COMBUSTION PRO-CESS; CONVECTIVE HEAT TRANSFER; CYLINDER PRESSURE DATA; ENGINE COMPRESSION; EQUILIBRIUM COMPOSITIONS; HEAT RELEASE ANALYSIS; INSTANTANEOUS HEAT FLUX; OPERATING CONDITION;

HEAT CONVECTION;

EID: 85072477055     PISSN: 01487191     EISSN: 26883627     Source Type: Journal    
DOI: 10.4271/2000-01-1265     Document Type: Conference Paper

References (42)

1. Foster, D.E., "An Overview of Zero-Dimensional Thermodynamic Models for IC Engine Data Analysis," SAE Paper No. 852070, 1985.
2. Gatowski, J.A., Balles, E.N., Chun, K.M., Nelson, F.E., Ekchian, J.A., and Heywood, J.B., "Heat Release Analysis of Engine Pressure Data," SAE Trans., Journal of Engines, Vol. 93, pp. 961-977, 1984.
3. Brunt, M.F.J., and Emtage, A.L., "Evaluation of Burn Rate Routines and Analysis Errors," SAE SP-1267, pp. 19-30, SAE Paper No. 970037, 1997.
4. Chun, K.M., and Heywood, J.B., "Estimating Heat- Release and Mass-of-Mixture Burned from Spark-Ignition Engine Pressure Data," Combust. Sci. and Tech., Vol. 54, pp. 133-143, 1987.
5. Brunt M.F.J., Rai, H., and Emtage, A.L., "The Calculation of Heat Release Energy from Engine Cylinder Pressure Data," SAE SP-1315, pp. 101-112, SAE paper No. 981052, 1998.
6. Shayler P.J., Wiseman, M.W., and Ma, T., "Improving the Determination of Mass Fraction Burnt," SAE Paper No. 900351, 1990.
7. Oppenheim, A.K., Barton, J.E., Kuhl, A.L., and Johnson, W.P., "Refinement of Heat Release Analysis," SAE Paper No. 970538, 1997.
8. Daniels, C.F., "The Comparison of Mass Fraction Burned Obtained from the Cylinder Pressure Signal and Spark Plug Ion Signal," SAE SP-1348, pp. 15-23, SAE Paper No. 980140, 1998.
9. Eriksson, L., "Requirements for and a Systematic Method for Identifying Heat-Release Model Parameters," SAE SP-1330, pp. 19-30, SAE Paper No. 980626, 1998.
10. Egnell, R., "Combustion Diagnostics by Means of Multizone Heat Release Analysis and NO Calculation," SAE Paper No. 981424, 1998.
11. Guezennec, Y.G., and Hamada, W., "Two-Zone Heat Release Analysis of Combustion Data and Calibration of Heat Transfer Correlation in an IC Engine," SAE SP-1415, pp. 1-17, SAE Paper No. 1999-01-0218, 1999.
12. Rassweiler, G.M., and Withrow, L., "Motion Pictures of Engine Flames Correlated with Pressure Cards," SAE Trans., Vol. 47, pp. 185-204, 1938.
13. Woschni, G., "A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine," SAE Trans., Vol. 76, pp. 3065-3083, 1967.
14. Eichelberg, G., "Some New Investigations on Old Combustion Engine Problems," Engineering, Vol. 148, pp. 463-547, 1939.
15. Annand, W.J.D., "Heat Transfer in the Cylinders of Reciprocating Internal Combustion Engines," Proc. Instn. Mech. Engrs., Vol. 177, No. 36, pp. 973-996, 1963.
16. Hohenberg, G.F., "Advanced Approaches for Heat Transfer Calculations," SAE Trans., Vol. 88, pp. 2788-2806, 1979.
17. Wang, C.S., and Berry, G.F., "Heat Transfer in Internal Combustion Engines," ASME Paper No. 85-WA/HT-23, 1985.
18. Woschni, G., and Spinder, W., "Heat Transfer with Insulated Combustion Chamber Walls and Its Influence on the Performance of Diesel Engines," ASME Trans., Journal of Engineering for Gas Turbines and Power, Vol. 110, pp. 482-502, 1988.
19. Woschni, G., and Huber, K., "The Influence of Soot Deposits on Combustion Chamber Walls on Heat Losses in Diesel Engines," SAE Paper No. 910297, 1991.
20. Assanis, D.N., and Badillo, E., "On Heat Transfer Measurements in Diesel Engines Using Fast-Response Coaxial Thermocouples," Proceedings, XII ETCE, Internal Combustion Engine Symposium, ICE-Vol. 6, Uzkan T., Ed., Book No.H00445, ASME, New York, pp. 25-32, 1989.
21. Alkidas, A.C., "Heat Transfer Characteristics of a Spark-Ignition Engine," ASME Trans., Journal of Heat Transfer, Vol. 102, pp. 189-193, 1980.
22. Enomoto Y., and Furuhama, S., "A Study of the Local Heat Transfer Coefficient on the Combustion Chamber Walls of a Four-Stroke Gasoline Engine," JSME International Journal, Series II, Vol. 32, No. 1, pp. 107-114, 1989.
23. Overbye, V.D., Bennethum, J.E., Uyehara, O.A., and Myers, P.S., "Unsteady Heat Transfer in Engines," SAE Trans., Vol. 69, pp. 461-494, 1960.
24. LeFeuvre, T., Myers, P.S., and Uyehara, O.A., "Experimental Instantaneous Heat Fluxes in a Diesel Engine and Their Correlation," SAE Paper No. 690464, 1969.
25. Dao, K., Uyehara, O.A., and Myers, P.S., "Heat Transfer Rates at Gas Wall Interfaces in Motored Piston Engine," SAE Trans., Vol 82, pp. 2237-2258, 1973.
26. Alkidas, A.C., and Myers, J.P., "Transient Heat-Flux Measurements in the Combustion Chamber of a Spark-Ignition Engine," ASME Trans., Journal of Heat Transfer, Vol. 104, pp. 62-67, 1982.
27. Alkidas, A.C., Puzinauskas, P.V., and Peterson, R.C., "Combustion and Heat Transfer Studies in a Spark-Ignited Multivalve Optical Engine," SAE Paper No. 900353, 1990.
28. Huber, K., Woschni, G., and Zeilinger, K., "Investigations on Heat Transfer in Internal Combustion Engines under Low Load and Motoring Conditions," Proceedings, XXIII FISITA Congress, ATA, Torino, Vol. I, pp. 151-159, 1990.
29. Alkidas, A.C., and Suh, I.-S., "The Effects of Intake-Flow Configuration on the Heat-Release and Heat-Transfer Characteristics of a Single-Cylinder Four-Valve S.I. Engine," SAE Trans., Journal of Engines, Vol. 100, pp. 323-336, 1991.
30. Annand, W.J.D., and Ma, T.H., "Instantaneous Heat Transfer Rates to the Cylinder Head Surface of a Small Compression-Ignition Engine," Proc. Instn. Mech. Engrs., Vol. 185, No. 72, pp. 976-987, 1971.
31. Annand, W.J.D., and Pinfold, D., "Heat Transfer in the Cylinder of a Motored Reciprocating Engine," SAE Paper No. 800457, 1980.
32. Kleinschmidt, W., "Developing a Mathematical Formula for Unsteady Heat Transfer in Engines," Proceedings, Eurotherm Seminar No. 15, IMFT, Toulouse, FR, pp. 139-147, 1991.
33. Bignardi, L., and Cipollone, R., "Unsteady Heat Transfer in Internal Combustion Engines," Proceedings, Eurotherm Seminar No. 15, IMFT, Toulouse, FR, pp. 149-161, 1991.
34. Kornhauser, A.A., and Smith, J.L., Jr., "Application of a Complex Nusselt Number to Heat Transfer During Compression and Expansion," ASME Trans., Journal of Heat Transfer, Vol. 116, pp. 536-542, 1994.
35. Gilaber, P., and Pinchon, P., "Measurements and Multidimensional Modeling of Gas-Wall Heat Transfer in a S.I. Engine," SAE Trans., Journal of Engines, Vol. 97, pp. 839-857, 1988.
36. Morel, T., Rackmil, C.I., Keribar, R., and Jennings, M.J., "Model for Heat Transfer and Combustion in Spark Ignited Engines and Its Comparison with Experiments," SAE Paper No. 880198, 1988.
37. Puzinauskas, P., and Borgnakke, C., "Evaluation and Improvement of an Unsteady Heat Transfer Model for Spark Ignition Engines," SAE Trans., Journal of Engines, Vol. 100, pp. 345-360, 1991.
38. Catania, A.E., Misul, D., Mittica, A., Spessa, E., and Ferrera, M., "Heat Release Analysis of Pressure Data in a Multivalve CNG Engine with Variable Intake-System Geometry," Paper No. F2000A082, to be presented at XXVIII FISITA Congress, Seoul, Korea, June 12-15, 2000.
39. Ferguson, C., "Internal Combustion Engines," John Wiley & Sons, 1986.
40. Catania, A.E., Misul, D., Spessa, E., and Martorana, G., "Conversion of a Multivalve Gasoline Engine to run on CNG," SAE Paper No. 2000-01-0673, SAE International Congress and Exposition, Detroit, MI, 2000.
41. Myers, J.P., and Alkidas, A.C., "Effects of Combustion-Chamber Surface Temperature on the Exhaust Emissions of a Single-Cylinder Spark-Ignition Engine," SAE Trans., Vol. 87, pp. 2483-2496, 1978.
42. Groff, E.G., Alkidas, A.C., and Myers, J.P., "Combustion Data for an Axisymmetric Homogeneous-Charge Spark-Ignition Engine," GM Research Publication, GMR-3577, 1981.