A design tool for tuning and optimizing carburizing and heat treat processes

SAE Technical Papers

Volumn , Issue , 2002, Pages

  Ferguson, B Lynn ^a   Freborg, Andrew M ^a  

^a Deformation Control Technology

Author keywords

[No Author keywords available]

Indexed keywords

APPLICATION PROGRAMS; COMPUTER AIDED SOFTWARE ENGINEERING;

DESIGN TOOL; HEAT TREATS; MASS DIFFUSION; MECHANICAL MODEL; QUENCHING AND TEMPERING; STEEL PARTS; TRANSFORMATION MODEL;

DESIGN;

EID: 85072449195     PISSN: 01487191     EISSN: 26883627     Source Type: Journal    
DOI: 10.4271/2002-01-1475     Document Type: Conference Paper

References (8)

1. Bammann D., et al., "Development of a Carburizing and Quenching Simulation Tool: A Material Model for Carburizing Steels Undergoing Phase Transformations" 2nd International Conference on Quenching and Control of Distortion, edited by Totten G.E., Howes M., Sjostrom S., Funatani K., ASMI, Cleveland, pp 367-375, November 1996.
2. th International Seminar on Heat Treatment and Surface Engineering of Light Alloys, IFHT, Budapest, pp 273-282, September 1999.
3. Prantil VC, et al., "Simulating Distortion and Residual Stresses in Carburized Thin Strips" submitted to ASME Journal of Engineering Materials and Technology.
4. Hildenwall B., "Prediction of the Residual Stresses Created During Quenching" Linkoping University, Linkoping Studies in Science & Technology, Dissertation No. 39, 1979.
5. th Heat Treating Society Conference, ASMI, St. Louis, October 9-12, 2000.
6. Krauss G., "Microstructures and Properties of Carburized Steels," Heat Treating, Vol. 4 of ASM Handbook, p 367, 1991.
7. Sinha A., Ferrous Physical Metallurgy, Butterworths, London, pp 705-713, 1989.
8. rd Int. Conf. On Quenching & Control of Distortion, ASMI, pp 188-200, 1999.