메뉴 건너뛰기




Volumn 65, Issue 10, 2002, Pages 1-15

Anomalies in the microwave power-dependent surface impedance of (formula presented) thin films

Author keywords

[No Author keywords available]

Indexed keywords


EID: 85038319348     PISSN: 10980121     EISSN: 1550235X     Source Type: Journal    
DOI: 10.1103/PhysRevB.65.104522     Document Type: Article
Times cited : (1)

References (47)
  • 18
    • 0014933089 scopus 로고
    • g. M. Eliashberg, Pis’ma Zh. Éksp. Teor. Fiz. 11, 186 (1970) [JETP Lett. 11, 114 (1970)].
    • (1970) JETP Lett. , vol.11 , pp. 114
    • Eliashberg, G.M.1
  • 22
    • 85038345351 scopus 로고    scopus 로고
    • private communication
    • M. A. Hein (private communication).
    • Hein, M.A.1
  • 38
    • 85038303043 scopus 로고    scopus 로고
    • At the moment of taking the microwave measurements presented in Sec. III both films were about 3 years old
    • At the moment of taking the microwave measurements presented in Sec. III both films were about 3 years old.
  • 41
    • 85038281737 scopus 로고    scopus 로고
    • The part of the film on which the majority of the measurements reported in this paper were made is referred to as “film TF2,” whereas the other part is referred to as the “reference part.”
    • Film TF2 was cleaved into two slabs shortly after the film fabrication. The part of the film on which the majority of the measurements reported in this paper were made is referred to as “film TF2,” whereas the other part is referred to as the “reference part.”
    • Film TF2 was cleaved into two slabs shortly after the film fabrication
  • 42
    • 85038326350 scopus 로고    scopus 로고
    • Though this relationship is not always unambiguous and may be influenced by other characteristics of the films (such as cation disorder, e.g.), in general for the films prepared by the same deposition method a longer c axis usually corresponds to the reduced oxygen content
    • Here we should note that in the x-ray measurements oxygen content is determined from the c-axis length. Though this relationship is not always unambiguous and may be influenced by other characteristics of the films (such as cation disorder, e.g.), in general for the films prepared by the same deposition method a longer c axis usually corresponds to the reduced oxygen content.
    • Here we should note that in the x-ray measurements oxygen content is determined from the c-axis length


* 이 정보는 Elsevier사의 SCOPUS DB에서 KISTI가 분석하여 추출한 것입니다.