LED Permanent Emergency Lighting System Based on a Single Magnetic Component

IEEE Transactions on Power Electronics

Volumn 24, Issue 5, 2009, Pages 1409-1416

  Cardesín, Jesús ^a   Ribas, Javier ^a   García García, Jorge ^a   Rico Secades, Manuel ^a   Calleja, Antonio Javier ^a   Corominas, Emilio Lopez ^a   Costa, Marco Antonio Dalla ^a  

^a UNIVERSITY OF OVIEDO   (Spain)

Author keywords

Battery charger; electronics ballast; permanent lighting system; power factor correction; power LEDs; switched mode power supply

Indexed keywords

EID: 85008049740     PISSN: 08858993     EISSN: 19410107     Source Type: Journal    
DOI: 10.1109/TPEL.2009.2013138     Document Type: Article

References (26)

1. M. Rico-Secades, E. L. Corominas, J. García-García, J. Ribas, A. J. Calleja, J. M. Alonso, and J. Cardesín, “Low cost electronic ballast for a 36-W fluorescent lamp based on a current-mode-controlled boost inverter for a 120 V DC bus power distribution,” IEEE Trans. Power Electron., vol. 21, no. 4, pp. 1099–1106, Jul. 2006.
2. J. M. Alonso, P. Villegas, J. Díaz, C. Blanco, and M. Rico-Secades, “A microcontroller-based emergency ballast for fluorescent lamps,” IEEE Trans. Ind. Appl., vol. 44, no. 2, pp. 207–216, Apr. 1997.
3. J. Spangler and A. K. Behera, “Power factor correction used for fluorescent lamp ballast,” in Proc. IEEE Ind. Appl. Spec. Conf., 1991, pp. 1836–1841.
4. R. L. Lin and Y.-T. Chen, “Electronic ballast for fluorescent lamps with phase-locked loop control scheme,” IEEE Trans. Power Electron., vol. 21, no. 1, pp. 254–262, Jan. 2006.
5. M. Rico-Secades, A. Calleja, J. Ribas, E. L. Corominas, J. M. Alonso, J. Cardesín, and J. García-García, “Evaluation of a low-cost permanent emergency lighting system based on high efficiency LEDs,” IEEE Trans. Ind. Appl., vol. 41, no. 5, pp. 1386–1390, Sep./Oct. 2005.
6. A. A. M. Oliveira, T. B. Marchesan, R. N. Prado, and A. Campos, “Distributed emergency lighting system LEDs driven by two integrated flyback converters,” in Proc. IEEE Ind. Appl. Soc. Conf., 2007, pp. 1141–1146.
7. M. Rico-Secades, J. García-García, J. Cardesín, and A. Calleja, “Using tapped converters as LED drivers,” in Proc. IEEE Ind. Appl. Spec. Conf., 2006, pp. 1794–1800.
8. K. Zhou, J. G. Zhang, S. Yuvarajan, and D. F. Weng, “Quasi-active power factor correction circuit for HB LED driver,” IEEE Trans. Power Electron., vol. 23, no. 3, pp. 1410–1415, May 2008.
9. Limits for Harmonic Current Emissions (Equipment Input Current ≤16A per Phase), IEC 61000–3-2 International Standard, International Electrotechnical Commission, 1995–03.
10. H. Endo, T. Yamashita, and T. Sigiura, “A high-power-factor buck converter,” in Proc. IEEE Power Electron. Spec. Conf., 1992, pp. 1071–1076.
11. R. de Oliveira Brioschi and J. L. F. Vieira, “High-power-factor electronic ballast with constant DC-link voltage,” IEEE Trans. Power Electron., vol. 13, no. 6, pp. 1030–1037, Jun. 1998.
12. M. C. Grahem, K. A. Haddad, and G. Roy, “Unity power factor scheme using cascade converters,” IEEE Trans. Ind. Electron., vol. 2, pp. 936–941, 1993.
13. M. A. Co, D. S. L. Simonetti, and J. L. F. Vieira, “High power factor electronic ballast operating at critical conduction mode,” in Proc. IEEE Power Electron. Spec. Conf., 1996, pp. 962–968.
14. I. Takahashi, “Power factor improvement of a diode rectifier circuit,” in Proc. IEEE Ind. Appl. Spec. Conf., 1990, pp. 1289–1294.
15. B. Singh, B. N. Singh, A. Chandra, K. Al-Haddad, A. Pandey, and D. P. Kothari, “A review of single-phase improved power quality AC–DC converters,” IEEE Trans. Ind. Electron., vol. 50, no. 5, pp. 962–981, Oct. 2003.
16. M. K. Kazimierczuk and W. Szaraniec, “Electronic ballast for fluorescent lamps,” IEEE Trans. Power Electron., vol. 8, no. 4, pp. 386–395, Oct. 1993.
17. A. J. Calleja, J. M. Alonso, E. L. Corominas, J. Ribas, J. A. Martínez, and M. Rico-Secades, “Analisis and experimental results of a single-stage high power factor electronic ballast based on flyback converter,” IEEE Trans. Power Electron., vol. 14, no. 6, pp. 998–1006, Nov. 1999.
18. T. Suntio, “Average and small-signal modelling of self-oscillating flyback converter with applied switching delay,” IEEE Trans. Power Electron., vol. 21, no. 2, pp. 479–486, Mar. 2006.
19. T. F. Wu and T. H. Yu, “Offline applications with single-stage converters,” IEEE Trans. Ind. Electron., vol. 44, no. 5, pp. 638–647, Oct. 1997.
20. M. T. Madigan, R. Erichson, and E. Ismail, “Integrated high quality rectifier-regulators,” IEEE Trans. Ind. Electron., vol. 46, no. 4, pp. 749–758, Aug. 1999.
21. E. Deng and S. Cuk, “Single stage, high power factor lamp ballast,” in Proc. IEEE Appl. Power Electron. Spec. Conf., 1994, pp. 441–449.
22. A. Silva de Morais, V. J. Farias, L. C. de Freitas, E. A. A. Coelho, and J. B. Vieira, “A high power factor ballast using a single switch with both power stages integrated,” IEEE Trans. Power Electron., vol. 21, no. 2, pp. 524–531, Mar. 2006.
23. M. Ponce, A. J. Martinez, J. Correa, M. Cotorogea, and J. Arau, “High-efficient integrated electronic ballast for compact fluorescent lamps,” IEEE Trans. Power Electron., vol. 21, no. 2, pp. 532–542, Mar. 2006.
24. E. L. Corominas, M. Rico-Secades, J. A. F. Rubiera, J. M. Alonso, A. J. Calleja, J. Ribas, and J. Cardesiin, “A novel low cost two-stage electronic ballast for 250W high pressure mercury vapour lamps based on current-mode-controlled back-boost inverter,” in Proc. IEEE Appl. Power Electron. Conf., 2001, pp. 676–682.
25. D. Linden, Handbook ofBatteries. New York: McGraw-Hill, 1995.
26. Y. Ren, M. Xu, J. Zhou, and F. C Lee, “Analytical loss model of power MOSFET,” IEEE Trans. Power Electron., vol. 21, no. 2, pp. 310–319, Mar. 2006.