Highway Bridge Assessment Using an Adaptive Real-Time Wireless Sensor Network

IEEE Sensors Journal

Volumn 9, Issue 11, 2009, Pages 1405-1413

  Whelan, Matthew J ^a   Gangone, Michael V ^a   Janoyan, Kerop D ^b  

^a CLARKSON UNIVERSITY   (United States)

^b Clarkson University   (United States)

Author keywords

Intelligent structures; structural health monitoring; vibration measurement; wireless sensor networks

Indexed keywords

EID: 85008033773     PISSN: 1530437X     EISSN: 15581748     Source Type: Journal    
DOI: 10.1109/JSEN.2009.2026546     Document Type: Article

References (14)

1. K.Wardhana and F. C. Hadipriono, “Analysis of recent bridge failures in the United States”, J. Perform. Constructed Facil., vol. 17, no. 3, pp. 140–150, 2003.
2. J.-H.Weng, C.-H. Loh, J. P. Lynch, K.-C. Lu, P.-Y. Lin, and Y.Wang, “Output-only modal identification of a cable-stayed bridge using wireless monitoring systems”, Eng. Struct., vol. 30, pp. 1820–1830, 2008.
3. S. N. Pakzad, G. L. Fenves, S. Kim, and D. E. Culler, “Design and implementation of scalable wireless sensor network for structural monitoring”, J. Infrastructure Syst., vol. 14, no. 1, pp. 89–101, 2008.
4. M. J. Whelan and K. D. Janoyan, “Design of a robust, high-rate wireless sensor network for static and dynamic structural monitoring”, J. Intell. Mater. Syst. Struct., vol. 20, no. 7, pp. 849–864, 2009, doi: 10.1177/ 1045389X08098768.
5. M. J. Whelan, M. V. Gangone, K. D. Janoyan, and R. Jha, “Real-time wireless vibration monitoring for operational modal analysis of an integral abutment highway bridge”, Eng. Structures, doi:10.1016/j.engstruct. 2009.03.022.
6. M. J. Whelan, M. V. Gangone, K. D. Janoyan, and R. Jha, “Operational modal analysis of a multi-span skew bridge using real-time wireless sensor networks”, submitted for publication.
7. G. Brisebois, “New instrumentation amplifiers maximize output swing on low voltage supplies”, Design Note 323, Linear Technology. Milpitas, CA, 2003.
8. LIS2L02AL MEMS Inertial Sensor Datasheet May 2006, STMicroelectronics, Inc. Rev. 2.
9. P. H. Garrett, High Performance Instrumentation and Automation. Boca Raton, FL: Taylor & Francis, 2005, ch. 5.
10. B. Peeters, “System identification and damage detection in civil engineering”, Ph.D. dissertation, Katholieke Universiteit Leuven, Leuven, Belgium, 2000.
11. B. Van den Branden, B. Peeters, and G. D. De Roeck, “Introduction to MACEC v2.0: Modal Analysis on Civil Engineering Constructions”, Katholieke Universiteit Leuven, User Guide and Case Studies, 47 p.
12. O. Hag-Elsafi and J. Kunin, “Load testing for bridge rating: Route 22 over Swamp River”, New York State Department of Transportation (NYSDOT), Special Rep., Feb. 2006.
13. R. R. Craig, Mechanics of Materials. Hoboken, NJ: Wiley, 2000, ch. 6.
14. R. M. Parker and J. A. Puckett, Design of Highway Bridges. New York: Wiley, 1997, ch. 4.