Wear characterization of direct steel-H20 specimens produced by additive manufacturing techniques

Advances in 3D Printing and Additive Manufacturing Technologies

Volumn , Issue , 2016, Pages 121-128

  Baig, Usaid Mohammed ^a   Anwar Khan, A R ^a   Ramesh Rajakumar, D ^b  

^a Ghousia College of Engineering   (India)

^b SURFACE ENGINEERING DIVISION   (India)

Author keywords

Additive manufacturing; Taguchi s orthogonal array; Wear rate and wear co efficient

Indexed keywords

COST EFFECTIVENESS; MANUFACTURE; QUALITY ASSURANCE; WATER; WEAR OF MATERIALS;

ADDITIVE MANUFACTURING TECHNOLOGY; AEROSPACE COMPONENTS; CATASTROPHIC FAILURES; MANUFACTURING TECHNIQUES; ORTHOGONAL ARRAY; PROTOTYPE TECHNIQUES; WEAR CHARACTERIZATION; WEAR RATES;

3D PRINTERS;

EID: 85006817305     PISSN: None     EISSN: None     Source Type: Book    
DOI: 10.1007/978-981-10-0812-2_11     Document Type: Chapter

References (6)

1. Kruth JP (1991) Material incress manufacturing by rapid prototyping techniques. Katholieke University Leuven/Belgium, Annals of the CRIP vol. 40/2/1991
2. Ramesh Rajakumar D, Rajeev G, Tushar P (2014) Mechanical characterization of steel specimens produced by rapid prototyping techniques for wind tunnel model applications. National Trisonic Aerodynamic Facilities, National Aerospace Laboratories, Bangalore
3. Luo RC, Chen C-C Tzou J-H (2004) The development of direct metallic rapid prototyping system. IEEE
4. Ranjith Roy K (2001) Design of experiments using Taguchi approach. Wiley-Interscience Publication
5. Wang PC A simple method to design good experiments. Department of Industrial and Business Management, Chang University, Taiwan
6. Marwaha R, Dev Gupta R, Jain V, Sharma K (2013) Experimental investigation and analysis of wear parameters on Al.Sic/Gr-metal matrix hybrid composite by Taguchi Method. Global J Res Eng Mech Mech Eng 13(9)