Investigation of scuffing resistance of piston rings run against piston ring grooves

Tribology Transactions

Volumn 51, Issue 5, 2008, Pages 621-626

  Zhang, W ^a   Becker, E ^b   Wang, Y ^b   Zou, Q ^a   Zhou, B ^b   Barber, G C ^a  

^a Oakland University   (United States)

^b GENERAL MOTORS CORPORATION   (United States)

Author keywords

Piston Ring; Ring Groove; Scuffing

Indexed keywords

EID: 85006523996     PISSN: 10402004     EISSN: 1547397X     Source Type: Journal    
DOI: 10.1080/10402000802044316     Document Type: Article

References (9)

1. Shuster, M. M., Stong, T., Deis, M. C. and Burke, D. C. (1999), “Piston Ring Cylinder Liner Scuffing Phenomenon: Investigation, Simulation and Prevention,” SAE1999 International Congress and Exposition, SAE Paper No. 1999-01-1219.
2. Enthoven, J. C., Cann, P M. and Spikes, H. A. (1993), “Temperature and Scuffing,” Trib. Trans., 36, 2, pp 258-266.
3. Wacker, E. (1981), “TheUse ofaTestingMachineforSimulatingPistonRing Groove Wear,” In Metallurgical Aspects Of Wear, DGM E.V., Hornbogen, E. and Zum Gahr, K.-H., Eds., pp 247-267.
4. Wong, T. Y., Scott, C. G., and Ripple, D. E. (1993), “Diesel Engine Piston Scuffing: A Preliminary Investigation,” SAE Paper No. 930687, SAE, Warrendale, PA.
5. Barrell, D.J.W., Prist, M. and Taylor, C.M. (1999), “BenchTest Study ofPiston Ring Flank and Piston Groove Interaction,” In Lubrication at the Frontier: The Role Ofthe Interface and Surface Layers in the Thin Film and Boundary Regime, Elsevier Science B.V., Dowson, D., Priest, M., Taylor, C.M., Ehret, P, Childs, T.H.C., Dalmaz, G., Berthier, Y., Flamand, L., Georges, J.-M., Lubrecht, A.A., Eds., pp 343-351.
6. Tomanik, E., Zabeu, C.B. and De Almeida, G.M. (2003), “Abnormal Wear on Piston Top Groove,” SAE Paper No. 2003-01-1102, SAE, Warrendale, PA.
7. Ludema, K.C. (1984), “A Review of Scuffing and Running Of Lubricated Surfaces, With Asperities and Oxides in Perspective,” Wear, 100, pp 315-331.
8. Blau, P. (1995), Private Communication Concerning A Ring-Groove Wear Test Apparatus, Built During a Cooperative Research and Development Project Between Oak Ridge National Laboratory and General Motors Corporation, and Supported in Part By U.S. Department of Energy, Office of Defense Programs.
9. Wang, Y., Tung, S.C., (1999), “Scuffing and Wear Behavior of Aluminum Piston Skirt Coatings against Aluminum Cylinder Bore,” Wear, 225-229, pp 1100-1108.