Challenges to achieving sustainable aqueous systems: A case study in metalworking fluids

Proceedings - 2nd International Symposium on Environmentally Conscious Design and Inverse Manufacturing

Volumn , Issue , 2001, Pages 566-571

  Skerlos, S J ^a   Adriaens, P ^a   Hayes, K ^a   Rihana, A ^a   Kurabayashi, K ^a   Takayama, S ^a   Zimmerman, J ^a   Zhao, Fu ^a  

^a UNIVERSITY OF MICHIGAN   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

FLUIDS; LIFE CYCLE; MANUFACTURE; MECHANICAL VARIABLES MEASUREMENT;

INDUSTRIAL UTILIZATION; LIFE-CYCLE ENVIRONMENTAL IMPACT; MANUFACTURING OPERATIONS; METALWORKING FLUIDS; RECENT RESEARCHES; SENSOR DEVELOPMENT; STATE OF THE ART; SYSTEM CHARACTERIZATION;

ENVIRONMENTAL IMPACT;

EID: 84963704542     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1109/ECODIM.2001.992425     Document Type: Conference Paper

References (8)

1. Sutherland, J. W., T. Cao, C. Daniel, Y. Yue, Y. Zheng, P. Sheng, D. Bauer, M. Srinivasan, R. E. DeVor, S.G. Kapoor, S.J. Skerlos, 1997, "CFEST: An Internet-Based Cutting Fluid Evaluation Software Testbed." Transaction of NAMRI/SME, Volume XXV, May, 1997, pp. 243-248.
2. Skerlos, S.J., DeVor, R.E., and Kapoor, S.G., 1998, "Environmentally Conscious Disposal Considerations in Cutting Fluid Selection", ASME International Mechanical Engineering Congress and Exposition, In Lee, J., ed., Proceedings of the ASME: Manufacturing Science and Engineering Division, Anaheim, CA, Vol. 8, pp. 397-403.
3. Environmental Protection Agency (EPA), 1994, 40 CFR 435.12, 40 CFR 435.15, Washington, D.C.
4. Independent Lubricant Manufacturers Association (ILMA), 2000, 1999 Volume Survey: Report on the Volume of Lubricants Manufactured in the United States and Canada by Indpendent Lubricant Manufacturers in 1999, p.1.
5. Klocke, F. and Eisenblatter, G., 1997, "Dry Cutting", Annals of the CIRP, Vol. 46, pp. 1-8.
6. NIOSH, 1998, Criteria for a Recommended Standard: Occupational Exposure to Metalworking Fluids, National Institute of Occupational Safety and Health, Cincinnati.
7. Byers, J.P. (editor), 1994, Metalworking Fluids. New York: Marcel Dekker.
8. Huh, D., Tung, Y-C., Grotberg, J.B., Skerlos, S.J., Kurabayashi, K., Takayama, S., 2001, "Air-Liquid Two-Phase Microfluidic System for Low-Cost, Low-Volume, and Low-Power Micro Flow Cytometer", Fifth International Symposium on Micro Total Analysis Systems (μTAS), Monterey, California, October 21-25, 2001.