Experimental analysis and modeling of internal combustion engine operating with wet ethanol

Fuel

Volumn 158, Issue , 2015, Pages 270-278

  Ambros W M ^a   Lanzanova, T D M ^a   Fagundez, J L S ^a   Sari, R L ^a   Pinheiro, D K ^a   Martins, M E S ^a   Salau, N P G ^a  

^a FEDERAL UNIVERSITY OF SANTA MARIA   (Brazil)

Author keywords

Internal combustion engine; Modeling heat transfer; Parameter estimation; Wet ethanol

Indexed keywords

COMBUSTION; COMBUSTION EQUIPMENT; COSTS; DISTILLATION; ENGINE CYLINDERS; ENGINES; ERRORS; ESTIMATION; ETHANOL; FUELS; HEAT TRANSFER; INTERNAL COMBUSTION ENGINES; PARAMETER ESTIMATION;

ENERGY EXPENDITURE; ENGINE OPERATING CONDITIONS; ENGINE PERFORMANCE; EXPERIMENTAL ANALYSIS; FIXED IGNITION TIMINGS; PERFORMANCE PARAMETERS; PRESSURE AND TEMPERATURE; SPECIFIC FUEL CONSUMPTION;

ETHANOL FUELS;

EID: 84930960072     PISSN: 00162361     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.fuel.2015.05.009     Document Type: Article

References (17)

1. National Agency of Petroleum, Natural Gas and Biofuels (ANP). Seventh resolution - 09/02/2011; 2011 < www.udop.com.br >.
2. Y. Zvirin, M. Gutman, and L. Tartakovsky Chapter 16 - Fuel Effects on Emissions E. Sher, Handbook of air pollution from internal combustion engines - Pollutant Formation and Control 1998 Academic Press San Diego 547 651 10.1016/B978-012639855-7/50055-7
3. L.C.M. Sales, and J.R. Sodré Cold start characteristics of an ethanol-fuelled engine with heated intake air and fuel Appl Therm Eng 40 2012 198 201
4. Steciak J, Beyerlein S, Jones H, Klein M, Kramer S, Wang X. Catalytic reactor studies. National Institute for Advanced Transportation Technology. Final report; September 2001.
5. Flowers DL, Aceves SM, Frias JM. Improving ethanol life cycle energy efficiency by direct utilization of wet ethanol in HCCI engines SAE papers no. 2007-01-1867; 2007.
6. J.R. Couper, W.R. Penney, J.R. Fair, and S.M. Walas Chemical process equipment: selection and design 2nd ed. 2005 Elsevier
7. R.B. Melton Jr, S.J. Lestz, R.D. Quillian Jr, and E.J. Rambie Direct water injection cooling for military engines and effects on the diesel cycle Symp Combust 15 2 1975 1389 1399
8. Greeves G, Khan I, Onion G. Effects of water introduction on diesel engine combustion and emission. In: Symp. Combust.; 1977.
9. A. Boretti Water injection in directly injected turbocharged spark ignition engines Appl Therm Eng 52 1 2013 62 68
10. M. Chiodi An innovative 3D-CFD approach towards virtual development of internal combustion engines 1st ed. 2011 Vieweg und Teubner Verlag
11. M.S. Lounici, K. Loubar, M. Balistrou, and M. Tazerout Investigation on heat transfer evaluation for a more efficient two-zone combustion model in the case of natural gas SI engines Appl Therm Eng 31 2010
12. C.R. Ferguson Internal combustion engines, applied thermosciences 1986 John Wiley & Sons
13. J.B. Heywood Internal combustion engine fundamentals 1988 McGraw-Hill Series in Mechanical Engineering
14. Fagundez JLS, Lanzanova TDM, Martins MES, Salau NPG. Heat transfer evaluation of an internal combustion engine - Part A & B. SAE papers no. 2014-36-0361 and no. 2014-36-0357; 2014.
15. Hohenberg GF. Advanced approaches for heat transfer calculations. SAE paper no. 790825; 1979.
16. J.R. Dormand, and P.J. Prince A family of embedded Runge-Kutta formulae J Comput Appl Math 6 1980 19 26
17. S. Saxena, D. Vuilleumier, D. Kozarac, M. Krieck, R. Dibble, and S. Aceves Optimal operating conditions for wet ethanol in a HCCI engine using gas heat recovery Appl Energy 116 1 2014 269 277