Fault detection for gas turbine sensors using I/O dynamic linear models methodology of fault code generation

Proceedings of the ASME Turbo Expo

Volumn , Issue , 1996, Pages

  Bettocchi, R ^a   Spina, P R ^a   Azzoni, P M ^a  

^a UNIVERSITY OF FERRARA   (Italy)

Author keywords

[No Author keywords available]

Indexed keywords

GAS TURBINES; GASES;

ANALYTICAL REDUNDANCY; DYNAMIC LINEAR MODEL; INDUSTRIAL GAS TURBINES; LINEAR DYNAMIC MODEL; MACHINE CONTROL SYSTEMS; MEASURABLE PARAMETERS; MEASURED PARAMETERS; OPERATING CONDITION;

FAULT DETECTION;

EID: 84928474068     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/96TA002     Document Type: Conference Paper

References (23)

1. Benvenuti, E., Bettocchi, R, Cantore, G., Negri Di Montenegro, G., Spina, P. R., 1993, "Gas Turbine Cycle Modeling Oriented to Component Performance Evaluation from Limited Design or Test Data", Proceedings, 7th ASME COGEN - TURBO, Bournemouth, U. K., pp. 327-337.
2. Benvenuti, E., Bettocchi, R., Cantore, G., Negri Di Montenegro, G., Spina, P. R., 1994, "Experimental Validation of a Gas Turbine Cycle Model Based on a Simultaneous Solution Method", Proceedings, 8th ASME COGEN - TURBO, Portland, U. S. A., pp. 245-255.
3. Bettocchi, R., Spina, P. R., Fabbri, F., 1996, "Dynamic Modeling of Single-Shaft Industrial Gas Turbine", ASME Paper 96-GT-332.
4. Gertler, J., 1988, "Survey of Model-Based Failure Detection and Isolation in Complex Plants", IEEE Control Systems Magazine, December, pp. 3-11.
5. Gertler, J., Singer, D., 1990, "A New Structural Framework for Parity Equation-Based Failure Detection and Isolation", Automatica, Vol. 26, No. 2, pp. 381-388.
6. Gertler, J., 1991, "Analytical Redundancy Methods in Fault Detection and Isolation", Proceedings, IFAC/IMACS - Symposium on "Fault Detection, Supervision and Safety for Technical Process", Baden-Baden, Germany.
7. Gottman, J. M., 1981, "Time Series Analysis. A Comprehensive Introduction for Social Scientists", Cambridge University Press, Cambridge, MA, U. S. A..
8. Isermann, R., 1984, "Process Fault Detection Based on Modeling and Estimation Methods - A Survey", Automatica, Vol. 20, pp. 387-404.
9. Isermann, R., 1993, "Fault Diagnosis of Machines via Parameter Estimation and Knowledge Processing - Tutorial Paper", Automatica, Vol. 29, No. 4, pp. 815-835.
10. Kelly, R. W., 1996, "Application of Analytical Redundancy to the Detection of Sensor Faults on a Turbofan Engine", ASME Paper 96-GT-3.
11. Lensi, R., Andrenucci, M., 1978, "Designing a Diagnostic Model for Gas Turbine Plants", Istituto di Macchine Universita di Pisa, Pisa, Italy.
12. Ljung, L., 1988, "System Identification Toolbox", The MathWorks Inc., South Natick, MA, U. S. A..
13. MathWorks Inc., 1990, "MATLAB User's Guide", South Natick, MA, U. S. A..
14. Merrington, G., 1989, "Fault Diagnosis of Gas Turbine Engines from Transient Data", ASME Journal of Engineering for Gas Turbines and Power, Vol. 111, pp. 237-243.
15. Merrington, G., Oh-Kyu Kwon, Goodwin, G., Carlsson, B., 1991, "Fault Detection and Diagnosis in Gas Turbines", ASME Journal of Engineering for Gas Turbines and Power, Vol. 113, pp. 276-282.
16. Ogata, K., 1987, "Discrete Time Control Systems", Prentice-Hall International, Englewood Cliffs, N. J., U. S. A..
17. Patton, R. J., Frank, P., Clark, R., 1989, "Fault Diagnosis in Dynamic Systems", Prentice-Hall International, U. K..
18. Pratt & Whitney Aircraft, 1965, "Malfunction Analysis Through Gas Generator Comparisons and Mechanical Trends", Information letter No. 18, November.
19. Pratt & Whitney Aircraft, 1968, "Malfunction Analysis Through Gas Generator Comparisons and Mechanical Trends", Information letter No. 18, September.
20. Stein, J. L., 1993, "Modeling and State Estimator Design Issues For Model-Based Monitoring Systems", ASME Journal of Dynamic Systems, Measurement, and Control, Vol. 115, pp. 318-327.
21. Urban, L. A., 1972, "Gas Path Analysis Applied to Turbine Engine Condition Monitoring", Proceedings, AIAA/SAE 8th Joint Propulsion Conference, New Orleans, USA.
22. Urban, L. A., 1974, "Parameter Selection for Multiple Fault Diagnostics of Gas Turbine Engine", ASME Paper 74-GT-62.
23. Young, P., 1981, "Parameter Estimation for Continuous-Time Models - A Survey", Automatica, Vol. 17, No. 1, pp. 23-39.