Field verification of simplified analysis procedures for segmental concrete bridges

Journal of Structural Engineering (United States)

Volumn 141, Issue 1, 2015, Pages

  Maguire, Marc ^a   Moen, Cristopher D ^b   Roberts Wollmann, Carin ^b   Cousins, Tommy ^b  

^a UTAH STATE UNIVERSITY   (United States)

^b VIRGINIA POLYTECHNIC INSTITUTE AND STATE UNIVERSITY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

BOX GIRDER BRIDGES; CONCRETES; DESIGN; STRUCTURES (BUILT OBJECTS);

BALANCED CANTILEVER; EQUIVALENT FRAME; FIELD VERIFICATIONS; INFLUENCE SURFACES; LONGITUDINAL ANALYSIS; SIMPLIFIED ANALYSIS; SINGLE-CELL STRUCTURES; TRANSVERSE BENDING;

CONCRETE BRIDGES;

EID: 84920854742     PISSN: 07339445     EISSN: None     Source Type: Journal    
DOI: 10.1061/(ASCE)ST.1943-541X.0001111     Document Type: Article

References (25)

1. Al-Omaishi, N., Tadros, M. K., and, Seguirant, S. J. (2009). " Elasticity modulus, shrinkage and creep of high-strength concrete as adopted by AASHTO." PCI J., 54 (3), 44-63. PCIJEE 0887-9672
2. Barker, J. M. (1978). Post-tensioned box girder bridge manual, Post Tensioning Institute, Phoenix, AZ.
3. Chung, W. S. (2003). " A cracked concrete material model for the non-linear finite element analysis of slab-on-girder bridges." Doctoral dissertation, Perdue Univ., West Lafayette, IN.
4. Collins, W. N. (2010). " Live load testing and analysis of the southbound span of U.S. Route 15 over Interstate-66." Master's thesis, Virginia Tech, Blacksburg, VA.
5. Davis, R. T., Thompson, M. K., Wood, B. A., Breen, J. E., and, Kreger, M. E. (1999). " Measurement-based performance evaluation of a segmental concrete bridge." Research Rep. No. 1404-3F, Texas Dept. of Transportation, Austin, TX.
6. Duemmel, P. S., Baber, T. T., Barton, F. W., and, McKeel, W. T. (1992). " Field instrumentation and measured response of the I-295 cable-stayed bridge: Part 1-Field study of live load responses." Rep. to Virinia Dept. of Transportation. Richmond, VA.
7. Hawkins, N. M., and, Clark, J. H. (1983). " Investigation of thermal and live load stresses in Denny Creek Viaduct." Rep. to Washington State Dept. of Transportation. Olympia, WA.
8. Homberg, H. (1968). Roadway slabs with variable thicknesses, Springer, New York.
9. Kuhn, D. (2008). " Transverse analysis and field measurements of segmental box girder bridges." Master's thesis, Florida State Univ., Tallahassee, FL.
10. Kurian, B., and, Menon, D. (2005). " Correction of errors in simplified transverse bending analysis of concrete box-girder bridges." J. Bridge Eng., 10.1061/(ASCE)1084-0702(2005)10:6(650), 650-657. JBENF2 1084-0702
11. Kurian, B., and, Menon, D. (2006). " Simplified method for transverse bending analysis of concrete box-girder bridges." J. Struct. Eng., 33 (2), 121-127. JSENEI 0970-0137
12. Kurian, B., and, Menon, D. (2008). " Transverse bending analysis of concrete box-girder bridges with flange overhangs." J. Struct. Eng., 35 (3), 173-179.
13. Libby, J. R. (1976). " Segmental box girder bridge superstructure design." ACI J., 73 (5), 279-290.
14. Lissenden, C. J. (1988). " Dynamic modeling of a cable stayed bridge during construction." Master's thesis, Univ. of Virginia, Charlottesville, VA.
15. Maguire, M. (2013). " Transverse and longitudinal bending of segmental box girder bridges." Doctoral dissertation, Virginia Tech, Blacksburg, VA.
16. McClure, R. M., and, West, H. H. (1980). " Field testing of an experimental segmental bridge." Interim Rep. Issue 8009, Pennsylvania Dept. of Transportation, Harrisonburg, PA.
17. McClure, R. M., Anderson, D. B., and, McDevitt, T. E. (1980). " Laboratory testing of segments for an experimental bridge." Interim Rep., Pennsylvania Dept. of Transportation, Harrisburg, PA.
18. Moreton, A. J. (1998). " Segmental analysis and design fundamentals." Recommended practice for design and construction of segmental concrete bridges, American Segmental Bridge Institute, Phoenix, AZ.
19. Pucher, A. (1977). Influence surfaces of elastic plates, Springer, New York.
20. Roberts-Wollmann, C. L., Breen, J. E., and, Kreger, M. E. (2001). " Live load tests of the San Antonio 'Y'." J. Bridge Eng., 10.1061/(ASCE)1084-0702(2001)6:6(556), 556-563. JBENF2 1084-0702
21. Sanayei, M., and, Onipede, O. B. R. (1992). " Selection of noisy measurement locations for error reduction in static parameter identification." Am. Inst. Aeronaut. Astronaut. J., 30 (9), 2299-2309. 10.2514/3.11218
22. Sennet, R. E. (2000). Matrix analysis of structures, Waveland Press, Long Grove, IL.
23. Takebayashi, T., Deeprasertwong, K., and, Leung, Y. W. (1994). " A full-scale destructive test of a precast segmental box girder bridge with dry joints and external tendons." Proc., ICE Struct. Build., 104 (3), 297-315. 10.1680/istbu.1994.26780
24. Tassin, D. M. (1998). " Design of precase segmental bridges build span-by-span." Recommended practice for design and construction of segmental concrete bridges, American Segmental Bridge Institute, Phoenix, AZ.
25. Thoman, S. J., Redfield, C. M., and, Hollenbeck, R. E. (1984). " Load test of single-cell box girder bridge cantilever deck." J. Struct. Eng., 10.1061/(ASCE)0733-9445(1984)110:8(1773), 1773-1785.