Primary jet characteristics within an isothermal gas turbine combustor

Proceedings of the ASME Turbo Expo

Volumn 2, Issue , 2001, Pages

  Carrotte, J F ^a   Griffiths, J P ^a   Spencer, A ^a  

^a LOUGHBOROUGH UNIVERSITY   (United Kingdom)

Author keywords

[No Author keywords available]

Indexed keywords

ALTERNATIVE FUELS; COAL COMBUSTION; FLOW FIELDS; FORECASTING; GAS TURBINES; ISOTHERMS; TUBES (COMPONENTS);

DISCHARGE COEFFICIENTS; EXPERIMENTAL INVESTIGATIONS; FLUID TRAJECTORIES; GAS TURBINE COMBUSTOR; INITIAL CONDITIONS; INTERNAL FLOW FIELD; JET CHARACTERISTICS; NUMERICAL PREDICTIONS;

COMBUSTORS;

EID: 84905750368     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/2001-GT-0057     Document Type: Conference Paper

References (21)

1. Barker,A.G. and Carrotte,J.F., 1997, "The Effect on Combustor Diffuser Pefonnance of Structural OGV/Pre-Diffuser Systems", ASME-97-GT-304.
2. Brocklehurst, H., 1994, "Fuel Injector Definition for the Phase 5 Combustor", Report CRR90209, Rolls-Royce plc.
3. Carrotte,J.F., Bailey,D.W. and Frodsham,C.W., 1995, "Detailed Measurements on a Modem Combustor Dump Diffuser System", Trans. ASME, Jnl. of Eng. For Gas Turbines and Power, Vol.117, pp.678-685.
4. Carrotte,J.F., Denman,P.A.,Wray,A.P. and Fry,P., (1993), "Detailed Performance Comparison of a Dump and Short Faired Diffuser System", ASME Paper No.93-GT-331
5. Carrotte,J.F. and Stevens,S.J., 1990, "The Influence of Dilution Hole Geometry on ,let Mixing", Trans. ASME Jnl. of Eng. For Gas Turbines and Power, Vol.112, pp.73-79.
6. Edwards,R.V., 1987, "Report of the Special Panel on Statistical Particle Bias Problems in Laser Anemometry", Trans. ASME Jnl. of Fluids Eng., Vol. 109, pp89-93.
7. Fishenden,C.R. and Stevens,S.J., 1977, "Performance of Annular Combustor Dump Diffusers", ,lnl. of Aircraft, Vol. 14, No. 1, pp.60-67.
8. Griffiths,J.P., 2000, "Measurements of the Flow Field within a Modem Gas Turbine Combustor", PhD Thesis, Loughborough University.
9. Jones, W.P. and Launder, B.E., 1973, "Prediction of Low Reynolds Number Phenomena With a Two Equation Model of Turbulence", Int. Jnl. Heat and Mass Transfer, 16, p1189.
10. Klein,A, 1995, "Characteristics of Combustor Diffusers", Prog. Aerospace Sci., Vol.31, pp. 171-271.
11. Lefebvre,A.W., 1983, "Gas Turbine Combustion", Mcgraw-Hill, USA.
12. Little, A.R. and Manners, A.P., 1993, "Predictions of the Pressure Losses In 2D and 3D Dump Diffusers" ASME Paper 93-GT-184, 38th ASME IGTE, Cincinatti, Ohio, 1993.
13. Mcguirk, J.J. and Spencer, A., 1993, "CFD Modelling of Annulus Port Flows", ASME paper 93-GT-185, ASME IGTE.
14. McGuirk,J.J and Palma,J.M.L.M., 1995, "Experimental Investigation of the Flow Inside a Water Model of a Gas Turbine Combustor: Part 1-Mean and Turbulent Flow Field", Trans. ASME, Jnl. of Fluids Eng., Vol. 117.
15. Mcguirk, J.J. and Spencer, A., 1995, "Computational Methods for Modelling Port Flows in Gas Turbine Combustors", ASME paper 95-GT-414, ASME IGTE 1995.
16. Mcguirk, J.J. and Spencer, A., 2000, "Coupled and Uncoupled CFD Prediction of the Characteristics of Jets From Combustor Air Admission Ports", ASME Paper 2000-GT-125.
17. Patankar, S.V. and Spalding, D.B., 1972, "A Calculation Procedure for Heat, Mass and Momentum Transfer in 3 Dimensional Parabolic Flows", Int. Jnl. Heat and Mass Transfer, 15, p1787.
18. Rhie, C.M. and Chow, W.L., (1982), "A numerical study of the turbulent flow past an isolated aerofoil", AIAA-82-0998.
19. Richards, C.D. and Samuelson,G.S., 1992, "The Role of Primary Jets in the Dome Region Aerodynamics of a Model Can Combustor", Trans. ASME ,lnl. of Engineering for Gas Turbines and Power", Vol.114, pp. 20-26.
20. Spencer,A., 1998, "Gas Turbine Combustor Port Flows", PhD Thesis, Loughborough University.
21. Srinivasan,R. and White,C., 1986, "Dilution Jet Mixing Program Supplementary Report", NASA Contract Report Nos. CR-175043.