Emissions-calibrated equilibrium heat release model for direct injection compression ignition engines

Fuel

Volumn 117, Issue PARTB, 2014, Pages 1096-1110

  Mattson, Jonathan M S ^a   Depcik, Christopher ^a  

^a University of Kansas   (United States)

Author keywords

Arrhenius; Biodiesel; Compression ignition; Emissions; Heat release

Indexed keywords

ARRHENIUS; COMBUSTION EFFICIENCIES; COMPRESSION IGNITION; COMPRESSION IGNITION ENGINE; HEAT RELEASE; INJECTION COMPRESSION IGNITION ENGINE; THERMO DYNAMIC ANALYSIS; TIME-EFFICIENT COMPUTATIONS;

AIR ENGINES; BIODIESEL; COMBUSTION; FUELS; PARTICULATE EMISSIONS; THERMOANALYSIS;

DIESEL ENGINES;

EID: 84887836046     PISSN: 00162361     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.fuel.2013.10.026     Document Type: Article

References (62)

1. D.E. Foster An overview of zero-dimensional thermodynamic models for IC engine data analysis 1985 SAE International
2. T.K. Jensen, and J. Schramm A three-zone heat release model for combustion analysis in a natural gas SI engine. - effects of crevices and cyclic variations on UHC emissions 2000 SAE International
3. D. Brand, C.H. Onder, and L. Guzzella Estimation of the instantaneous in-cylinder pressure for control purposes using crankshaft angular velocity 2005 SAE International
4. I. Friedrich, H. Pucher, and T. Offer Automatic model calibration for engine-process simulation with heat-release prediction 2006 SAE International
5. I.I. Vibe Brennverlauf und kreisprozess von verbrennungsmotoren 1969 VEB Verlag Technik Berlin
6. R. Egnell A simple approach to studying the relation between fuel rate heat release rate and NO formation in diesel engines 1999 SAE International
7. Matekunas FA. Engine combustion control with ignition timing by pressure ratio management. Google Patents; 1986.
8. M.C. Sellnau Cylinder-pressure-based engine control using pressure-ratio-management and low-cost non-intrusive cylinder pressure sensors SAE Trans 109 3 2000 899 918
9. P.J. Shayler, M.W. Wiseman, and T. Ma Improving the determination of mass fraction burnt 1990 SAE International
10. B.M. Grimm, and R.T. Johnson Review of simple heat release computations 1990 SAE International
11. M. Klein A specific heat ratio model and compression ratio estimation Division of vehicular systems, department of electrical engineering 2004 Linköping University
12. J.B. Heywood Internal combustion engine fundamentals 1988 McGraw-Hill, Inc. 930p
13. G.V.J. Sastry, and H. Chandra A three-zone heat release model for di diesel engines 1994 SAE International
14. M. Lapuerta, O. Armas, and J.J. Hernández Diagnosis of DI diesel combustion from in-cylinder pressure signal by estimation of mean thermodynamic properties of the gas Appl Therm Eng 19 5 1999 513 529 (Pubitemid 129497895)
15. M.F.J. Brunt, H. Rai, and A.L. Emtage The calculation of heat release energy from engine cylinder pressure data 1998 SAE International
16. M.F.J. Brunt, and K.C. Platts Calculation of heat release in direct injection diesel engines 1999 SAE International
17. J.M.S. Mattson Power, efficiency and emissions optimization of a single cylinder direct-injected diesel engine for testing of alternative fuels through heat release modeling Department of mechanical engineering, school of engineering 2013 University of Kansas Lawrence (KS)
18. H. Hiroyasu, T. Kadota, and M. Arai Development and use of a spray combustion model to predict diesel engine efficiency and pollutant emission Bull JSME 26 24 1983 569 575 (Pubitemid 13559277)
19. Hiroyasu H, Nishida K. Simplified three-dimensional modeling of mixture formation and combustion in a DI diesel engine.; 1989.
20. T. Kadota, H. Hiroyasu, and H. Oya Spontaneous ignition delay of a fuel droplet in high pressure and high temperature gaseous environments Bull JSME 19 130 1976 437 445
21. C. Depcik Instructional use of a single-zone, premixed charge, spark-ignition engine heat release simulation Int J Mech Eng Educ 35 1 2007 1 31 (Pubitemid 350047346)
22. P. Tamilporai Simulation and analysis of combustion and heat transfer in low heat rejection diesel engine using two zone combustion model and different heat transfer models 2003 SAE International
23. Y.G. Guezennec, and W. Hamama Two-zone heat release analysis of combustion data and calibration of heat transfer correlation in an I.C. engine 1999 SAE International
24. A. Bahadori, and H.B. Vuthaluru Predicting emissivities of combustion gases Chem Eng Prog 105 6 2009 38 41
25. G. Woschni A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine 1967 SAE International
26. Kee RJ, et al. CHEMKIN-III: a FORTRAN chemical kinetics package for the analysis of gas-phase chemical and plasma kinetics. Livermore, CA: Sandia National Laboratories; 1996.
27. R.R. Chu Two-parameter equations of state for ARPCS applications 2001 SAE International
28. S.C. Low, and M. Feng Prediction of pressure fluctuation in the inlet and exhaust system of engine using a real gas model 2001 SAE International
29. J.C. Ragone Emission reduction and assisted combustion strategies for compression ignition engines with subsequent testing on a single-cylinder engine Department of mechanical engineering 2012 University of Kansas Lawrence (KS)
30. E. Cecrle An investigation of the effects of biodiesel feedstock on the performance and emissions of a single-cylinder diesel engine Energy Fuels 2012
31. R. UdayaKumar, and M.S. Anand Multizone combustion model for a four stroke direct injection diesel engine 2004 SAE International
32. G. Stiesch, and G.P. Merker A phenomenological model for accurate and time efficient prediction of heat release and exhaust emissions in direct-injection diesel engines 1999 SAE International
33. D.N. Assanis A methodology for cycle-by-cycle transient heat release analysis in a turbocharged direct injection diesel engine 2000 SAE International
34. P.K. Kundu, and I.M. Cohen Fluid mechanics 4th ed. 2010 Academic Press 872p
35. Alkhulaifi K, Hamdalla M. Ignition delay correlation for a direct injection diesel engine fuelled with automotive diesel and water diesel emulsion. World Acd Sci Eng Technol, 2011.
36. V. Gopalakrishnan, and J. Abraham An investigation of ignition and heat release characteristics in a diesel engine using an interactive flamelet model 2003 SAE International
37. J.R. Howell, R. Siegel, and M.P. Mengüç John R. Howell, Robert Siegel, M. Pinar Mengüç, Thermal radiation heat transfer 2011 CRC Press Boca Raton, Fl.
38. H.H. Wolfer Ignition lag in diesel engines VDI-Forschungsheft 1938 392
39. Stringer FW, Clarke AE, Clarke JS. The spontaneous ignition of hydrocarbon fuels in a flowing system. In: Proceedings of the institution of mechanical engineers, conference proceedings. vol. 184, No. 10. SAGE publications; 1969, p. 212-25.
40. N.A. Henein, and J.A. Bolt Correlation of air charge temperature and ignition delay for several fuels in a diesel engine 1969 SAE International
41. Itoh Y, Henein NA. Determination of ignition delay in diesel engines from constant volume vessels data. In: Proceedings of ASEM-ICE spring technical conference. New York; 1997.
42. K. Toshikazu, H. Hiroyuki, and O.Y.A. Hideo Spontaneous ignition delay of a fuel droplet in high pressure and high temperature gaseous environments Bull JSME 19 130 1976 437 445
43. H.O. Hardenberg, and F.W. Hase An empirical formula for computing the pressure rise delay of a fuel from its cetane number and from the relevant parameters of direct-injection diesel engines 1979 SAE International
44. N. Watson, A.D. Pilley, and M. Marzouk A combustion correlation for diesel engine simulation 1980 SAE International
45. L.J. Spadaccini Autoignition characteristics of hydrocarbon fuels at elevated temperatures and pressures J Eng Power 99 1977 83 87
46. L.J. Spadaccini, and J.A. Tevelde Autoignition characteristics of aircraft-type fuels Combust Flame 46 1982 283 300
47. T.W. Ryan, and T.J. Callahan Engine and constant volume bomb studies of diesel ignition and combustion 1988 SAE International
48. H. Fujimoto, T. Shimada, and G. Sato Study of diesel combustion in a constant volume vessel Trans Japan Soc Mech Eng 45 392 1979 599 609
49. F. Pischinger, U. Reuter, and E. Scheid Self-ignition of diesel sprays and its dependence on fuel properties and injection parameters J Eng Gas Turbines Power 110 1988 399 404 (Pubitemid 18648630)
50. Lahiri D et al. Utilization of oxygen-enriched air in diesel engines: fundamental considerations. In: Paper No. 97-ICE-72. New York; 1997.
51. G. Weisser, F.X. Tanner, and K. Boulouchos Modeling of ignition and early flame development with respect to large diesel engine simulation 1998 SAE International
52. H. Ando, J. Takemura, and E. Koujina A knock anticipating strategy basing on the real-time combustion mode analysis 1989 SAE International
53. M. Syrimis, K. Shigahara, and D.N. Assanis Correlation between knock intensity and heat transfer under light and heavy knocking conditions in a spark ignition engine 1996 SAE International
54. M.D. Checkel, and J.D. Dale Computerized knock detection from engine pressure records 1986 SAE International
55. G.F. Hohenberg Advanced approaches for heat transfer calculations 1979 SAE International
56. M.D. Mangus Design, construction, and validation of an in-cylinder pressure recording system for internal combustion engine analysis Department of mechanical engineering, school of engineering 2012 University of Kansas Lawrence (Kansas)
57. M. Mangus, and C. Depcik Comparison of ULSD, used cooking oil biodiesel, and JP-8 performance and emissions in a single-cylinder compression-ignition engine SAE Int J Fuels Lubr 5 3 2012 1382 1394
58. P.K. Barua Biodiesel from Seeds of jatropha found in assam, india Int J Energy, Inf Commun 2 2011 53 65
59. D.A. Kouremenos, C.D. Rakopoulos, and D.T. Hountalas Experimental investigation of the performance and exhaust emissions of a swirl chamber diesel engine using JP-8 aviation fuel Int J Energy Res 21 12 1997 1173 1185 (Pubitemid 127549306)
60. M. Canakci, and J.H. Van Gerpen Comparison of engine performance and emissions for petroleum diesel fuel, yellow grease biodiesel, and soybean oil biodiesel Trans ASAE 46 4 2003 937 944 (Pubitemid 37358451)
61. D.N. Assanis A predictive ignition delay - correlation under steady-state and transient operation of a direct injection diesel engine J Eng Gas Turbines Power 125 2003 450 457 (Pubitemid 40231471)
62. R.D. Chalgren A controlled EGR cooling system for heavy duty diesel applications using the vehicle engine cooling system simulation 2002 SAE International