Digital compensation of Rogowski coil's output voltage

IEEE Transactions on Instrumentation and Measurement

Volumn 62, Issue 1, 2013, Pages 71-82

  Hemmati, Esmaeil ^a   Mohammad Shahrtash, S ^a  

^a IRAN UNIVERSITY OF SCIENCE AND TECHNOLOGY   (Iran)

Author keywords

Electrical power cables; model free approach; partial discharge (PD) measurement; primary current reconstruction; Rogowski coil

Indexed keywords

FREQUENCY RESPONSE; PARTIAL DISCHARGES;

COMPENSATION METHOD; DIGITAL COMPENSATION; DIGITAL TECHNIQUES; ELECTRICAL POWER; INHERENT CHARACTERISTICS; INPUT CURRENT; MEASURED SIGNALS; MODEL FREE; OUTPUT VOLTAGES; PARTIAL DISCHARGE MEASUREMENTS; PARTIAL DISCHARGE SIGNAL; ROGOWSKI COIL; SHIELDED COILS;

ELECTRIC COILS;

EID: 84871012102     PISSN: 00189456     EISSN: None     Source Type: Journal    
DOI: 10.1109/TIM.2012.2212502     Document Type: Article

References (23)

1. Z. S. Zhang, D. M. Xiao, and Y. Li, "Rogowski air coil sensor technique for on-line partial discharge measurement of power cables," IET Sci. Meas. Tech., vol. 3, no. 3, pp. 187-196, May 2009.
2. M. Argueso, G. Robles, and J. Sanz, "Implementation of a Rogowski coil for the measurement of partial discharges," Rev. Sci. Instrum., vol. 76, no. 6, pp. 065107-1-065107-7, Jun. 2005.
3. G. Robles, M. Argueso, J. Sanz, R. Giannetti, and B. Tellini, "Identification of parameters in a Rogowski coil used for the measurement of partial discharges," in Proc. IEEE Instrum. Meas. Technol., May 2007, pp. 1-4.
4. G. Robles, J. M. Martinez, J. Sanz, B. Tellini, C. Zappacosta, and M. Rojas, "Designing and tuning an air-cored current transformer for partial discharges pulses measurements," in Proc. IEEE Instrum. Meas. Technol., May 2008, pp. 2021-2025.
5. W. F. Ray and R. M. Davis, "Wide bandwidth Rogowski current transducers Part 2-The Rogowski coil," EPE J., vol. 3, no. 2, pp. 116-122, Jun. 1993.
6. W. F. Ray and C. R. Hewson, "High performance Rogowski current transducers," in Proc. IEEE Ind. Appl. Conf., 2000, vol. 5, pp. 3083-3090. (Pubitemid 32031828)
7. L. Yi, L. Fuchang, Z. Qin, and Z. Heqing, "Design and construction of a Rogowski coil for measuring wide pulsed current," IEEE Sensors J., vol. 11, no. 1, pp. 123-130, Jan. 2011.
8. G. M. Hashmi, M. Lehtonen, and M. Nordman, "Modeling and experimental verification of on-line PD detection in MV covered-conductor overhead networks," IEEE Trans. Dielectr. Elect. Insul., vol. 17, no. 1, pp. 167-180, May 2010.
9. G. M. Hashmi, M. Lehtonen, and M. Nordman, "Calibration of online partial discharge measuring system using Rogowski coil in coveredconductor overhead distribution networks," IET Sci. Meas. Tech., vol. 5, no. 1, pp. 5-13, Jan. 2011.
10. V. Dubickas and H. Edin, "High-frequency model of the Rogowski coil with a small number of turns," IEEE Trans. Instrum. Meas., vol. 56, no. 6, pp. 2284-2288, Dec. 2007. (Pubitemid 350268461)
11. L. Ferkovic, D. Ilic, and R. Malaric, "Mutual inductance of a precise Rogowski coil in dependence of the position of primary conductor," IEEE Trans. Instrum. Meas., vol. 58, no. 1, pp. 122-128, Jan. 2009.
12. M. Chiampi, G. Crotti, and A.Morando, "Evaluation of flexible Rogowski coil performances in power frequency applications," IEEE Trans. Instrum. Meas., vol. 60, no. 3, pp. 854-862, Mar. 2011.
13. E. Abdi-Jalebi and R. McMahon, "High-performance low-cost Rogowski transducers and accompanying circuitry," IEEE Trans. Instrum. Meas., vol. 56, no. 3, pp. 753-759, Jun. 2007. (Pubitemid 46784542)
14. L. J. A. Kojovic, "Application of Rogowski coils used for protective relaying purposes," in Proc. Power Syst. Conf. Expo., 2006, pp. 538-543.
15. X. Zhang and L.-H. Mu, "Design for digital integrator of Rogowski coil based on pipeline structure," in Proc. Power Energy Eng. Conf., 2010, pp. 1-4.
16. M. Xu, H. Gao, G. Yuan, R. Yang, and G. Zou, "A novel correctingmethod for transient errors of CVT," in Proc. Develop. Power Syst. Protection, 2010, vol. 5, pp. 1-5.
17. H. Dommel, "Digital computer solution of electromagnetic transients in single-and multiphase networks," IEEE Trans. Power App. Syst., vol. PAS-88, no. 4, pp. 388-399, Apr. 1969.
18. J. Izykowski, B. Kasztenny, E. Rosolowski, M. M. Saha, and B. Hillstrom, "Dynamic compensation of capacitive voltage transformers," IEEE Trans. Power Del., vol. 13, no. 1, pp. 116-122, Jan. 1998. (Pubitemid 128741461)
19. The Vector Fitting Web Site. [Online]. Available: http://www.energy. sintef.no/Produkt/VECTFIT/index.asp
20. B. Gustavsen and A. Semlyen, "Rational approximation of frequency domain responses by vector fitting," IEEE Trans. Power Del., vol. 14, no. 3, pp. 1052-1061, Jul. 1999.
21. B. Gustavsen, "Improving the pole relocating properties of vector fitting," IEEE Trans. Power Del., vol. 21, no. 3, pp. 1587-1592, Jul. 2006. (Pubitemid 43983690)
22. D. Deschrijver,M.Mrozowski, T. Dhaene, and D. De Zutter, "Macromodeling of multiport systems using a fast implementation of the vector fitting method," IEEE Microw. Wireless Compon. Lett., vol. 18, no. 6, pp. 383-385, Jun. 2008.
23. Y. Kopsinis and S. McLaughlin, "Development of EMD-based denoising methods inspired by wavelet thresholding," IEEE Trans. Signal Process., vol. 57, no. 4, pp. 1351-1362, Apr. 2009.