Advancements in polymer-filler derived ceramics

Journal of the Korean Ceramic Society

Volumn 49, Issue 4, 2012, Pages 279-286

  Greil, Peter ^a  

^a UNIVERSITY OF ERLANGEN NUREMBERG   (Germany)

Author keywords

Polymer filler derived ceramics; Rate controlled pyrolysis; Surface modification

Indexed keywords

BULK MATERIALS; CERAMIC COMPONENT; FRACTIONAL DENSITY; GAS-SOLID REACTION; HIGH POTENTIAL; LAMINATE DESIGN; MICROSTRUCTURE EVOLUTIONS; MICROSTRUCTURE TAILORING; POLYMER-FILLER; PRECERAMIC POLYMER; PROPERTY IMPROVEMENT; SI-BASED CERAMICS;

CERAMIC MATERIALS; DENSITY (SPECIFIC GRAVITY); FILLERS; MICROSTRUCTURE; POLYMERS; SURFACE TREATMENT;

FILLED POLYMERS;

EID: 84865426507     PISSN: 12297801     EISSN: None     Source Type: Journal    
DOI: 10.4191/kcers.2012.49.4.279     Document Type: Conference Paper

References (44)

1. P. Colombo, G. Mera, R. Riedel, and G. D. Sorarù, "Polymer-Derived Ceramics: 40 Years of Research and Innovation in Advanced Ceramics," J. Am. Ceram. Soc., 93 1805-37 (2010).
2. R. Riedel, A. Kienzle, W. Dressler, L. Ruwisch, J. Bill, and F. Aldinger, "A Silicoboron Carbonitride Ceramic Stable to 2000°C," Nature, 382 796-8 (1996). (Pubitemid 26299559)
3. S. R. Shah and R. Raj, "Mechanical Properties of a Fully Dense Polymer Derived Ceramic Made by A Novel Pressure Casting Process," Acta Mater., 50 4093-103 (2002). (Pubitemid 35011419)
4. R. Kumar, S. Prinz, Y. Cai, A. Zimmermann, F. Aldinger, F. Berger, and K. Müller, "Crystallization and Creep Behaviour of Si-B-C-N Ceramics," Acta Mater., 53 4567-78 (2005). (Pubitemid 41263379)
5. D. L. Williamson and R. Raj, "A Model for Nano Domains in Polymer-Derived SiCO," J. Am. Ceram. Soc., 89 2188-95 (2006). (Pubitemid 43941534)
6. T. Ishikawa, Y. Kohtoku, K. Kumagawa, T. Yamamura, and T. Nasagawa, "High-Strength Alkali-Resistant Sintered SiC Fibre Stable up to 2200°C," Nature, 391 773-5 (1998). (Pubitemid 28099670)
7. A. R. Bunsell and A. Piant, "A Review of the Development of Three Generations of Small Diameter Silicon Carbide Fibres," J. Mater. Sci., 41 823-39 (2006).
8. J. D. Torrey and R. K. Bordia, "Mechanical Properties of Polymer-derived Ceramic Composite Coatings on Steel," J. Eur. Ceram. Soc., 28 253-7 (2008). (Pubitemid 47629645)
9. C. A. Lewinsohn and S. Elangovan, "Development of Amorphous Non-Oxide Seals for Solid Oxide Fuel Cells," Ceram. Eng. Sci. Proc., 24 317-22 (2003).
10. P. Colombo, "Engineering Porosity in Polymer-Derived Ceramics," J. Eur. Ceram. Soc., 28 1389-95 (2008).
11. N. R Nagaiah, J. S. Kapat, L. An, and L. Chow, "Novel Polymer Derived Ceramic-High Temperature Heat Flux Sensor for Gas Turbine Environment," J. Phys. : Conf. Ser., 34 458-63 (2006). (Pubitemid 43812466)
12. L. Liew, W. Zhang, V.M. Bright, L. An, M.L. Dunn, and R. Raj, "Fabrication of SiCN Ceramic MEMS Using Injectable Polymer-Precursor Technique," Sensors and Actuators: A. Physical, 89 64-70 (2001). (Pubitemid 32254941)
13. P. Greil, "Net Shape Manufacturing of Polymer Derived Ceramics," J. Eur. Ceram. Soc., 18 1905-14 (1998). (Pubitemid 129521805)
14. Y. L. Li, H. Fan. D. Su, C. Fasel, and R. Riedel, "Synthesis, Structure and Properties of Bulk Si(O), C Ceramics from Polycarbosilazane," J. Am. Ceram. Soc., 92 2175-218 (2009).
15. M. Esfehanian, R. Oberacker, T. Fett, and M. J. Hoffmann, "Development of Dense Filler-Free Polymer-Derived SiOC Ceramics by Field-Assisted Sintering," J. Am. Ceram. Soc., 91 3803-5 (2008).
16. S. Ishihara, H. Gu, J. Bill, F. Aldinger, and F. Wakai, "Densification of Precursor-Derived Si-C-N Ceramics by High-Pressure Hot Isostatic Pressing," J. Am. Ceram. Soc., 85 1706-12 (2002). (Pubitemid 34813587)
17. P. Greil, "Active Filler Controlled Pyrolysis of Preceramic Polymers (AFCOP)," J. Am. Ceram. Soc., 78 835-48 (1995).
18. P. Greil, "Pyrolysis of Active and Passive Filler-Loaded Preceramic Polymers" in Handbook of Advanced Ceramics, Edtrs. S. Somiya et al., pp.369-390, Elsevier Inc., 2003.
19. P. E. Sanchez-Jimenez, J. A. Downs, and R. Raj, "Transient Viscous Flow During the Evolution of a Ceramic (Silicon Carbonitride) from a Polymer (Polysilazane)," J. Am. Ceram. Soc., 93 2567-70 (2010).
20. S.J. Lombardo and Z.C. Feng, "Pressure Distribution During Binder Burnout in Three-dimensional Porous Ceramic Bodies with Anisotropic Permeability," J. Mat. Res., 17 1434-40 (2002). (Pubitemid 34789756)
21. R. Sachanandani and S.J. Lombardo, "Modeling of Green Body Strength, Internal Pressure and Stress in Porous Ceramic Bodies During Thermal Debinding," J. Ceram. Proc. Res., 12 5-11 (2011).
22. T. Hoefner, "Manufacturing and Properties of Porous Silicate based Ceramics for Ceramic Shaping," PhD Thesis, Univ. Erlangen, Germany, 2009.
23. S.J. Lombardo and R.V. Shende, "Determination of Binder Decomposition Kinetics for Specifying Heating Parameters in Binder Burnout Cycles from Three-Dimensional Porous Green Bodies," J. Am. Ceram. Soc., 85 780-6 (2002).
24. M. Steinau, N. Travitzky, T. Zipperle, and P. Greil, "Functionally Graded Ceramics Derived from Preceramic Polymers," in Advances in Polymer Derived Ceramics and Composites, Ceram. Trans., 213 61-71, Wiley, NY, 2010
25. A. Schkutow, "Measurement of Residual Stresses in Polymer Derived Multilayer Ceramics," Bachelor Thesis, University of Erlangen (2011).
26. 2/polysiloxane," PhD Thesis, Univ. Erlangen-Nuernberg, Germany, 1996.
27. S. J. P. Durham, K. Shanker, and R. A. L. Drew, "Carbothermal Synthesis of Silicon Nitride: Effect of Reaction Conditions," J. Am. Ceram. Soc., 74 31-7 (1991).
28. M. Scheffler, T. Gambaryan-Roisman, T. Takahashi, J. Kaschta, H. Muenstedt, P. Buhler, and P. Greil, "Pyrolytic Decomposition of Organo Polysiloxanes," Ceram. Trans., 115 239-50 (2000).
29. R. Larker, "Reaction Sintering and Properties of Silicon Oxynitride Densified by Hot Isostatic Pressing," J. Am. Ceram. Soc., 75 [1] 62-66 (1992).
30. F.L. Riley, "Silicon Nitride and Related Materials," J. Am. Ceram. Soc., 83 245-65 (2000).
31. 2CS15319J (2012).
32. 2-Derived Composite Ceramics," J. Am. Ceram. Soc., 84 2256-9 (2001).
33. L. Toma, H.-J. Kleebe, M.M. Müller, E. Janssen, R. Riedel, T. Melz, and H. Hanselka, "Correlation Between Intrinsic Microstructure and Piezoresistivity in a SiOC Polymer-Derived Ceramic," J. Am. Ceram. Soc., 95 1056-61 (2012).
34. A. Geissinger, J. Oberle, W. Teschner, H. Boeder, and K.-H. Heussner, "Ceramic Electric Resistor," US Patent 5, 961 888 (1999).
35. S. Jung, D. Seo, S.J. Lombardo, Z.C. Feng, J.K. Chen, and Y. Zhang, "Fabrication using Filler Controlled Pyrolysis and Characterization of Polysilazane PDC RTD Arrays on Quartz Wafers," Sensors and Actuators: A. Physical, 175 53-9 (2012).
36. X. Yan, X. Cheng, G. Han, R. Hauser, and R. Riedel, "Synthesis and Magnetic Properties of Polymer Derived Metal/SiCN Ceramic Composites," Key Engin. Mat., 353-8, 1485-8 (2007).
37. L. Biasetto, A. Francis, P. Palade, G. Principi, and P. Colombo, "Polymer-derived Micro-cellular SiOC Foams with Magnetic Functionality," J. Mat. Sci., 43 4119-26 (2008).
38. H. Denver, T. Heiman, E. Martin, A. Gupta, and D.-A. Borca-Tasciuc, "Fabrication of Polydimethylsiloxane Composites with Nickel Nanoparticle and Nanowire Fillers and Study of Their Mechanical and Magnetic Properties," J. Appl. Phys., 106 064909 (2009).
39. M. Steinau, N. Travitzky, J. Gegner, J. Hofmann, and P. Greil, "Polymer-Derived Ceramics for Advanced Bearing Applications," Adv. Eng. Mat., 10 1141-6 (2008).
40. M. Günthner, A. Schütz, U. Glatzel, K. Wang, R.K. Bordia, O. Greißl, W. Krenkel, and G. Motz, "High Performance Environmental Barrier Coatings, Part I: Passive Filler Loaded SiCN System for Steel," J. Eur. Ceram. Soc., 31 3003-10 (2011).
41. K. Wang, M. Günthner, G. Motz, and R.K. Bordia, "High Performance Environmental Barrier Coatings, Part II: Active Filler Loaded SiOC System for Superalloys," J. Eur. Ceram. Soc., 31 3011-20 (2011).
42. E. Bernardo, G. Parcianello, P. Colombo, J.H. Adair, A.T. Barnes, J.R. Hellmann, B.H. Jones, J. Kruise, and J.J. Swab, "SiAlON Ceramics from Preceramic Polymers and Nano-sized Fillers: Application in Ceramicjoining," J. Eur. Ceram. Soc., 32 1329-35 (2012).
43. J. Zeschky, F. Goetz-Neunhoeffer, J. Neubauer, S.H. Jason Lo, B. Kummer, M. Scheffler, and P. Greil, "Preceramic Polymer Derived Cellular Ceramics," Comp. Sci. Techn., 63 2361-70 (2003). (Pubitemid 37375090)
44. J. Zeschky, J. Lo, T. Hoefner, and P. Greil, "Mg-alloy Infiltrated Si-O-C Foams," Mat. Sci. Eng. A., 215-21 (2005).